No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Dirección de corte: Mano derecha.
Material: Aleación de acero para herramientas.
Rosca de flauta recta con diseño de flauta recta, utilizado para agujero pasante y agujero ciego poco profundo, no para golpear agujeros ciegos.
Consejos
Antes de tocar, confirma si el diámetro del agujero redondo es adecuado y toma medidas de protección cuando trabajas. Al golpear, es necesario añadir agua o refrigerante para enfriarse para evitar la temperatura excesiva y reducir la pérdida del llave. Si encuentra dificultades en la rotación, el golpeteo debe suspenderse. Asegúrate de seleccionar el aceite de corte adecuado para el complejo proceso de roscado y aplicar aceite antioxidante para el mantenimiento después de su uso.
Jordan
Comentado en los Estados Unidos el 4 de marzo de 2025
Works great! My only gripe is that the shank is really small. Half the size of my snap-on. Which made finding something to help turn it pretty difficult. Ended up using an adjustable wrench. I used the tap to chase some threads on my intake manifold so it’s not like I was making new holes.I recommend the seller linking a tool with these taps to turn them. For the money spent on these it’s a no brainer to give them a try. They worked well for me with cast aluminum.***In my photo the broken tap is the SNAP-ON tap. I put them next to each other for size reference of the SHANK.***MY TAP FROM THIS REVIEW DID NOT BREAK. That’s the one I replaced with these!
Rich
Comentado en los Estados Unidos el 8 de febrero de 2025
I was a bit concerned about this little specialty tap due to price and country of origin. I was wonderfully surprised. First use was threading a small part made from 304 SS. Cut through it like butter. Great little tap. I haven't used it alot yet (other than in Delrin) so I'm not sure how long it will last, but out of the gate I'm really pleased.
Midnight Toker 70
Comentado en los Estados Unidos el 21 de febrero de 2025
I needed to tap some tiny 2mm holes for my RC cars. These worked perfectly. Good value, size correct. Good overall experience. Thank you!
Lone Biker of the Apacolypse
Comentado en los Estados Unidos el 16 de febrero de 2025
Need to tap a hole? Look no further than this fine and dandy item. Yes, you too could be cutting a grove that any machinist would be proud to call his own. Don’t have a hole to tap? don’t despair, you could use this as a really fancy corkscrew. Just drill a hole into a cork, tap out threads with this handy tool, insert the proper bolt, grip with a vice grip, and voila, you can pull out the cork with greater confidence and aplomb than the most snooty sommelier.
engle
Comentado en los Estados Unidos el 18 de agosto de 2024
Worked well.
Productos recomendados
Mex $365.49
Mex $ 168 .00 Mex $168.00
Mex $182.04
Mex $ 109 .00 Mex $109.00
Mex $307.55
Mex $ 147 .00 Mex $147.00