No hay artículos en el carro
No hay artículos en el carroLa revista Milwaukee Collated fue diseñada para trabajar con la pistola de tornillo M18 FUEL Drywall para aumentar la productividad. Alimenta las tiras de tornillo suavemente y tiene un cono de nariz cónico para caber en espacios compactos. El ajuste de profundidad del tornillo está enrasado para que no se ajuste accidentalmente. El ajuste de longitud del tornillo funciona con tornillos de hasta 2 pulgadas y todas las principales marcas. El modo de arranque automático de la pistola de tornillo de yeso M18 FUEL continúa trabajando con el accesorio mientras reduce el ruido entre los tornillos y proporciona una vida útil 3 veces más larga.
Willis R.
Comentado en los Estados Unidos el 5 de marzo de 2025
Nice and smooth
Tammy Studzinski
Comentado en los Estados Unidos el 3 de abril de 2025
Great product
Bob in Illinios
Comentado en los Estados Unidos el 27 de octubre de 2023
Works great. No more pricked fingers grabbing loose screws from a tool pouch. We had to spray it with a little WD-40 once in a while but not very often. Installing the longer bit in the drill was a chore. The outter collar just pulled off the drill, no tools needed. But the bit was hard to remove. I clamped the bit in a vise and yanked on the drill to remove it. To install the new one, I stuck teh bit in the drill, place the point of the bit on the bench and hit the back of the drill with my hand to lock it in. So far he has installed drywall in his 2000 sq/ft home and still on the first bit. He was familiar with these types of drills and knew to adjust this feeder for the screw length. As others have said, It is not that good for corners since the nose is so wide.
Jacob H
Comentado en los Estados Unidos el 6 de abril de 2023
I wish they would curve the edges of the red plastic because when you're screwing tight against walls or other obstacles it stops you up and a screw only goes in halfway. If you're screwing out in the open this thing is great. I also wish the attachment didn't come off so easily and it is difficult to get the long number 2 Phillips bit to stay in the drywall gun. When I was first assembling it I had to hit the number two bit on a brick wall to get it to seat correctly.
Jpena325
Comentado en los Estados Unidos el 6 de junio de 2019
Overall it was difficult to start, it was my first time with such an attachment. I didn’t realize that there was a bit holder I had to remove, without doing so I wasn’t able to put the long bit on and drive screws in correctly. Once I had it set it took time to dial in my proper depth,steel studs a bit more difficult but once I hit dead center I was flying across the walls. A great addition for me, it does make the tool a bit ackward to hold and does add weight to it but once you get used to it and you will, the driving goes a lot smoother . Occasionally the screw won’t seat flush that’s because you missed the stud possibly from going so fast. After all that it’s a great addition to the drywall gun very happy with it.
Productos recomendados