No hay artículos en el carro
No hay artículos en el carroRoger williamson
Comentado en el Reino Unido el 6 de marzo de 2025
Better than expected. Steel not Alloy
mon
Comentado en Japón el 13 de noviembre de 2024
中古で入手したYAMAHAのRGX421のロックナットのブロックが欠品していたため、ブロックを使用できないかと思い購入しました。商品の画像と説明にブロックサイズが書いていなかった不安でしたが、ブリッジサイズからあたりをつけて購入を決めました。ブリッジのサイズはYAMAHAの方が小さかったのですが、結局ブロックのサイズが合わず入りませんでした。ブロックのサイズが11.6mmぐらいで、YAMAHAの方は、最低10.8mm以下じゃないと入らないんですよね。。結局ホームセンターでM6の四角板ナット買ってはめました。商品自体は悪くないと思います。
WEBER
Comentado en Francia el 21 de septiembre de 2024
Dommage, moins bien fait que celui en chrome que j'avais déjà installé, et le malgré la largeur identique de 42, l'alignement de cordes n'est pas bon...vraiment dommage
Robert Miller
Comentado en Alemania el 21 de agosto de 2023
It does not have the measurements of an R3 Locking Nut. The height is not correct, this one is shorter. As for the quality, Looks to me the same as the material used by the Floyd Rose Special
Customsound79
Comentado en los Estados Unidos el 10 de marzo de 2023
I picked up a used Jackson RR3 that some joker installed a very wrong sized nut on. I have about 5 Floyd nuts sitting around but none of them fit right so I took a chance on this one. The width, string spacing and 1st fret action are pretty darn spot-on. That never happens. I filled and drilled new holes and the included screws were fine. I was prepared to have to route the shelf but am thrilled that it was an easy install.
Customer
Comentado en México el 10 de septiembre de 2023
Llegó antes de tiempo, pero la pieza es recta no curva como el diapasón de la guitarra, así que la tercera y cuarta cuerda prácticamente pegan en los trastes.
Productos recomendados