Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

10 piezas HSS H7 cortador de máquina escariador de flauta recta 3/4/5/6/7/8/9/10/11/12 mm escariadores de mandril

Envío gratis en pedidos superiores a Mex $600.00

Mex $589.00

Mex $ 282 .00 Mex $282.00

En stock

Acerca de este artículo

  • Material de fabricación del escariador de máquina: Material: HSS(H7 acero de alta velocidad
  • Tipo: brocas de escariador de flauta recta
  • Amplia aplicación: la herramienta escariadora es ampliamente utilizada para el mecanizado de agujeros, instalada en máquinas de perforación, fresadoras, etc



ByTheLake
Comentado en los Estados Unidos el 3 de noviembre de 2024
As other reviewers have stated, these reamers get shipped all piled together in a vinyl bag that is not worth saving for storage. Most of the cutting edges have slight damage from handling. If you only need these for an occasional bore for home projects, they should work, but if you need the highest precision, pay for a better set.
Shopper
Comentado en los Estados Unidos el 26 de junio de 2021
Bought these for a one time job in plastic. Didn't expect high quality, but they came so dinged up from being shipped in a plastic baggie that I had to stone them just to get a few holes done.They were barely sharp, finish sucked.
Todd Hunt
Comentado en los Estados Unidos el 22 de junio de 2021
Seems like a decent hobby quality set if reamers. The plastic pouch goes straight to the trash but I hats not an issue.
Dr Bonkers
Comentado en los Estados Unidos el 11 de junio de 2021
I just replaced the tuners on my Squier Bullet Strat that I bought used years ago, because the tuners had so much play in them after years of use, that they had no tuning stability anymore.To enlarge the the holes to fit most standard tuners, I used this set.First use the 9mm bit then the 10mm bit with your electric drill. Mark the the depth you need to ream using painter's tape on the bit after measuring the depth you need on the new tuners themselves.5 minutes and the holes were enlarged painlessly with no chip outs.The pouch they come in was heat sealed shut so I surgically used a box cutter to gain access to the bit. But the plastic on the pouch is painfully thin, so the bit will start to poke through the bottom with minor handling. Keep the ziplock bag that they shipped in and you have a fine storage containers. These are really nice reamers for the money.
K. H.
Comentado en los Estados Unidos el 20 de marzo de 2021
They seem to work well accurate enough unless you are looking for aircraft specs but works good for me
Productos recomendados

Mex $5,218.00

Mex $ 1,881 .00 Mex $1,881.00

4.8
Elegir