No hay artículos en el carro
No hay artículos en el carroAn ACDelco GM Original Equipment Engine Camshaft Position Sensor monitors the rotational position of the camshaft(s), and is a GMrecommended replacement for your vehicle’s original component. It provides a signal to the engine control module, which compares the camshaft position with the crankshaft position to determine ignition and fuel injection timing. This original equipment engine camshaft position sensor has been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. .
Mauricio Hernandez
Comentado en México el 6 de agosto de 2024
excelente servicio
Oscar
Comentado en México el 25 de julio de 2024
Aun no lo instalo, tengo duda que sea original
G H
Comentado en los Estados Unidos el 25 de julio de 2024
Perfect match if you are looking to replace the camshaft position sensor. (2018 Traverse)
Customer
Comentado en los Estados Unidos el 30 de junio de 2024
I bought an aftermarket and my car was leaking then I bought this one and it fit as it should, good product.
Feel better 😌
Comentado en los Estados Unidos el 9 de diciembre de 2024
Fit right in old 1,s place
Jo
Comentado en los Estados Unidos el 11 de diciembre de 2024
Perfect part
Antonio Vázquez Rodríguez
Comentado en México el 20 de junio de 2022
Todo bien y llego antes del tiempo de entrga
Alessandra Lambertini
Comentado en México el 12 de abril de 2022
Le quedó a mi Captiva Sport 2013 4 cilindros, la luz de check engine no se fue porque al parecer necesita reemplazo de dos sensores iguales a este, no solo de uno.
Lauri Olin
Comentado en los Estados Unidos el 23 de agosto de 2019
Usually these are very easy to install but the thing you should keep in mind as magnetically balance Motors use full synthetic oil and if you're not using full synthetic it's probably the oil not your sensor replace the oil is full synthetic and then I think you might be surprised but it's not the sensors but if you are already using full synthetic senso oil and you are still receiving codes then most likely it is the sensor needing to be replaced it is not a myth conventional oil cannot be used on magnetic balanced Motors especially Ecotech
Productos recomendados
Mex $398.00
Mex $ 214 .00 Mex $214.00
Mex $391.83
Mex $ 211 .00 Mex $211.00
Mex $205.82
Mex $ 111 .00 Mex $111.00