No hay artículos en el carro
No hay artículos en el carroUn interruptor de liberación de puerta elevadora ACDelco GM es un reemplazo recomendado por GM para el componente original de tu vehículo. Libera el pestillo de la puerta elevadora para permitir que el portón trasero se abra. Este interruptor de liberación de puerta de elevación del equipo original se ha fabricado para adaptarse a su vehículo GM, proporcionando el mismo rendimiento, durabilidad y vida útil que usted espera de General Motors.
D
Comentado en los Estados Unidos el 29 de septiembre de 2023
Had a 2009 CTSV that didn't work to pop the trunk from the outside. The third brake lights seals leaked, and would pour water in the trunk all the time. My old switch did NOT work. It was very crunchy inside, and one of those wires was broken at the switch. I cut the wires AT the switch, stripped off an inch of wire and used adhesive lined heat shrink and used an uninsulated, crimp butt connector and hooked up the new one. Works perfectly! (Make sure to seal up your third brake light. I used some clear silicone that I let sit and set up for the better part of a day)
Sebia
Comentado en los Estados Unidos el 19 de abril de 2023
I just joined it and it worked right away. No problems so far
Carlos M.
Comentado en México el 9 de agosto de 2022
Funcionó perfectamente en mi CTS 2008
Guy Hague
Comentado en Canadá el 8 de septiembre de 2021
Switch has to be connected by soldering or connectors .. works perfect !
JM
Comentado en Canadá el 13 de julio de 2020
no issues with it yet. super easy to install. pop out old one, cut wires close by, solder, shrinkwrap and voila! Saves you from opening up back door panels.
Iamedgeman
Comentado en los Estados Unidos el 13 de enero de 2020
Installed on a 2010 Cadillac CTS.The trunk release button was not to hard to install. Watch a YouTube video to see how. When deciding which button to buy, I debated on ordering one with the factory connector on it. Well I made the right choice because I had to cut the wire anyways. The wires were wrapped right into the wiring harness, no connector on it. Did have to file the end if the plastic base a little to get the button base to fit into the housing though. The button did not seem to work right away for some reason. I had to click it about 10x before it really started to work. After that it worked great.There is no need to take any of the covering in the trunk off. Just pop the button out of the trunk handle, cut the wire, properly attach the wires and snap the button into place.While doing this we did have to fix a couple broken wires in the harness loop hanging down from the trunk lid to the trunk. Looks like the wires cracked over time. These wires were for the license plate lights and the interior trunk light.Hope this helps.
Productos recomendados
Mex $409.48
Mex $ 217 .00 Mex $217.00
Mex $462.26
Mex $ 208 .00 Mex $208.00
Mex $99.00
Mex $ 51 .00 Mex $51.00