No hay artículos en el carro
No hay artículos en el carroDylan v.
Comentado en Canadá el 18 de junio de 2023
Le produit convient très bien et je le recommande pas de casse tête pour l’installation il fait très bien
Wendy V
Comentado en Canadá el 16 de febrero de 2023
We ordered this hatch release, for an older Chevy Equinox, it works Great!!!!
Oscar Juvenal Velázquez Rodríguez
Comentado en México el 19 de octubre de 2023
Llegó en perfectas condiciones, es el número de parte correcto y ajustó perfectamente en el auto.
Marla Gabriela Gonzalez banda
Comentado en México el 4 de diciembre de 2022
Sirve este para una equinox 2010
Brad
Comentado en los Estados Unidos el 26 de diciembre de 2022
This worked great on 2003 Buick Rendezvous. The old button was a pain, you had to try and push all over it to find a spot that would open the rear hatch. Installed the new one and working great again. Have to remove trim on inside of rear hatch and then the nuts that hold the cover over the switch. Once that cover is off I used torx bit with 1/4" driver to get the 2 screws and came out no problem. Maybe 30 mins total time for the swap.
Barreto
Comentado en México el 13 de noviembre de 2022
Un producto exelente y original quedó perfecto que más puedo decir gracias
FlyNavy
Comentado en los Estados Unidos el 9 de agosto de 2021
I have little mechanical ability. Had an old 2007 Torrent where the liftgate wouldn't open. Did some internet diagnosis while waiting for a repair shop appt a week and a half in the future. It pointed to this part. Watched a video and figured it was worth trying.This was much cheaper than a parts store and I had it in a day or 2. Went by the video and managed to get it installed. Best part was that it worked! Saved quite a bit of $$$ and got it fixed much faster. Part worke great.
cjm.photography
Comentado en Canadá el 14 de febrero de 2020
Very easy to install. Hope it works longer than the garbage junk yard door latch button I installed a year ago.Step 1. Find the hole covered by circular cover on back door.Step 2. Find the loop you pull to open the door. Tip you PUSH the loop and the door latch will open.Step 3. Remove back doors plastic wall cover. There are two screws at the bottom of door.Step 4. Unscrew old door latch button. There are two screws above the licence plate.Step 5. Unplug old door latch button. Plug in new.Step 6. TEST NEW DOOR LATCH BUTTON before you Close the back door.Step 7. Have a nice day and if you read this, I hope it helped.
Productos recomendados