No hay artículos en el carro
No hay artículos en el carroEl triturador de aire de servicio pesado ONYX Astro 727 está diseñado para aplicaciones de calidad profesional. Funciona en acero laminado en frío de calibre 17, y puede alimentarse a través de láminas de metal sin deformación de los bordes. Esta unidad puede cortar más de una pulgada por segundo, con un balance inigualable. Especificaciones: Velocidad RPM: 3,500 CPM Capacidad de corte: Acero: calibre 17 Consumo de aire: 2 cfm Entrada de aire: 1/4 "Longitud total: 7.7" Peso: 1.79 lbs
the gman in NM
Comentado en los Estados Unidos el 10 de diciembre de 2024
Firstly, shipping was super fast which is always good. Secondly, item appears to be well made and finished. No sharp edges anywhere, it's difficult to describe but if you're a tool person, you know what I mean when I say it feels good in the hand.Cuts metal within the limits of the specification easily. As with most air tools, it is very loud in operation so ear protection is recommended. Air consumption was fairly accurate I think. You're not going to be happy using it with a small pancake air compressor as it will cycle all the time. I have a 60 gallon 5hp compressor and it cycled enough while using the nibbler that I could tell a smaller compressor likely wouldn't work very well.I used it for cutting holes in 29g metal roofing panels and it sometimes struggled when it came to cutting through the ribs, just because of the acute angle caused as the throat of the nibbler went from the flat of the sheet to climb the rib. A little practice and it became a bit easier to force it to climb.One thing I didn't see covered in the manual is that you can actually change the orientation of the cutting head. As shipped, it cuts directly in line with the long length of the tool. However, by loosening the main nut on the head, you can switch the cutting direction by 90 degrees at a time. Hence, if you needed to trim something at a right angle to the handle, you can simply switch the head in less than 2 minutes. This was a nice feature.I didn't lube it every time I used it but enough that I could tell the difference when it needed air tool oil and it runs very well with good lube. Overall, I am very pleased with this tool and would unreservedly recommend it.
Diesel Ted
Comentado en los Estados Unidos el 5 de septiembre de 2024
Cutting trailer roof panels 100% worth the money. Cuts like butter
Ridley
Comentado en Singapur el 21 de marzo de 2023
Totally disappointed when I got it, I can see that there are sign or people trying to open this item using a spanner with the amount of scratches on it. I return it immediately
StyleDeVie
Comentado en Canadá el 30 de julio de 2020
Ne semble pas être bien adapté pour une coupe en ligne droite pour de la tôle ondulée de toiture et pour le soffit, il a du mal à passer les bosses de la tôle.Sinon l'outil est de bonne qualité et facile à manoeuvrer, la coupe est nette, franche et propre. A été utiliser avec un compresseur à air (de 110 psi environ).
Mathieu Moore
Comentado en Canadá el 22 de octubre de 2020
Perfect ! Thank You !
Productos recomendados
Mex $590.00
Mex $ 306 .00 Mex $306.00
Mex $1,203.81
Mex $ 577 .00 Mex $577.00
Mex $586.44
Mex $ 263 .00 Mex $263.00