No hay artículos en el carro
No hay artículos en el carro
- Cuando la línea de alimentación entra a través de la L1 y L2/N, por favor atornilla para penetrar la capa aislante de las líneas eléctricas. Es fácil de manejar.
Brian
Comentado en los Estados Unidos el 23 de noviembre de 2024
I installed 1 on my Dryer and 1 on my Central AC , i am righting down the usage numbers each month so i know what these appliances are using just by themselves , do not cut your wires to install this, be sure all covers are on before turning power back on, I have duel single phase electric, I installed mine beside my main electric panel, do not try this on your own if you do not know how electric works and you if you have not worked with electric before, you can NOT reset the numbers after reading ,same as your main electric meter,
Karl Lindheimer
Comentado en los Estados Unidos el 2 de octubre de 2024
I bought this Kilowatt hour meter and installed it in a clear-cover junction box next to my 240 volt hot water heater to monitor power used. My apartment has a separate feed to the water heater, bypassing the indoor fuse-box where I have a whole-house energy monitor. So to get total energy consumed, I add this reading to the other monitor and both combined usually match the KwH meter on side of building. But it's much easier to just check my indoor meters rather than trek outside.
Jill Elliott
Comentado en Canadá el 27 de diciembre de 2023
Works fine. No complaints.
Israel
Comentado en México el 3 de marzo de 2022
Buen producto llegó antes de lo esperado,lo recomiendo
Yusaf A.
Comentado en Canadá el 13 de septiembre de 2022
Using it to track my EV usage on the 240V supply (2 phase + ground). Installation was easy and straight forward.The device doesn’t have CSA or UL mark, only CE.
Ross Heitkamp
Comentado en los Estados Unidos el 17 de diciembre de 2013
I was hesitant to buy this at first because the picture showed a 50 Hz model and I wasn't sure from the markings whether it would handle 20 amps or 100 amps - I wanted something for 50 amps of 240 volts for charging my Tesla. After a few questions and getting prompt answers from the vendor, I felt assured and purchased it.Connections are pretty straight forward, but you are dealing with very high power and voltage so it is better left to an electrician if you are unsure. This needs to be mounted inside a box so that connections are all protected. I fit it in a standard Jbox, just barely, with a customized cover plate, but I saw some ready made boxes are available and those seem like a good choice.This has been working well for me for several months. A little red dot flashes to indicate energy being delivered. This cross checks well to the Tesla's built-in measurement of kWh and provides a nice running total to help you make decisions such as what electrical rate plan to choose. It also can help you see the "phantom power" used by leaving the car plugged in after a full charge.
Productos recomendados
Mex $298.00
Mex $ 134 .00 Mex $134.00
Mex $306.00
Mex $ 168 .00 Mex $168.00
Mex $226.99
Mex $ 118 .00 Mex $118.00