No hay artículos en el carro
No hay artículos en el carroFrank Clarke
Comentado en Canadá el 5 de septiembre de 2024
Great little tool, good quality, good price, great performance in the toughest wood.
Mickie
Comentado en los Estados Unidos el 13 de enero de 2022
Needed to drill a couple of holes in kitchen floor, that is 2 1/4” thick. This bit hooked up to my Milwaukee 1/2” drill made short work of the job. Topside hole.was very clean and pretty smooth. Bottom hole was a little jagged, but not bad. I would buy this bit again.
Marcos Alfonso Lopez Padilla
Comentado en México el 3 de enero de 2021
Bastante sólida y filosa. Hay que tener la precaucion en usarla a las revoluciones adecuadas y sobre todo en madera dura, realmente realiza el trabajo casi sola solo hay que sujetar el taladro con firmeza es necesario el mango auxiliar y protección ocular debido a que se desbasta la madera. Excelente producto.
Brian and Val
Comentado en los Estados Unidos el 31 de octubre de 2014
This is one solidly engineered tool! Simply put if your goal is to create a hole through wood quickly, this is your bit. If your goal is to drill to a certain depth and stop, this might not be your first choice.The center screw bites quickly and pulls the bit into the wood without the ability to control the speed. This could be dangerous if you don't have a good grip on your drill or the proper leverage like hanging off a ladder or working in an awkward position.If I was using a corded drill and was drilling through studs in a house this would be my first choice hands down. I was using it to drill through driftwood only an inch or two then stopping and its impossible.TIP- If you need to slow the bit take a grinder and take down the edges of the screw piece slightly and you will still have a sharp fast bit but will have control over the speed.
slow reader
Comentado en los Estados Unidos el 17 de enero de 2014
I got this bit to make holes in fresh pine log. This bit really works. The only thing i had to do it bring my corded drill. Battery on my portable drill is too weak.
Howard Hotard
Comentado en los Estados Unidos el 3 de marzo de 2010
This bit went above and beyond my expectations. Easy to use, stays sharp, saved me a lot of time. It is not a hole saw so you need to be careful of doing damage depending on the type of material you are cutting. What a great addition to my tool box.
Productos recomendados