No hay artículos en el carro
No hay artículos en el carro Nombre del producto: driver LED.
Potencia: 12-18 W.
entrada de voltaje: AC85-165 V.
Voltaje de salida: CC 36-72 V.
Corriente: 300 mA ± 5 %.
Material: plástico.
Aplicación: panel de luz LED.
Nota: bajo la guía de la instalación eléctrica
One of the Guziks
Comentado en los Estados Unidos el 4 de junio de 2021
I like the fact that the connector is compatible with my overhead LED light fixtures and the same small footprint as the existing unit that failed.
ALBAN A
Comentado en Francia el 24 de octubre de 2019
Produit conforme au descriptifPenser a vérifier les caractéristiques techniques
Cecil Henry
Comentado en los Estados Unidos el 17 de abril de 2019
a bit different than the originals but only because there is a delayed start compared to the other 2 originals. bought 4 to replace 1 and have a spare for all 3 lights. wire plug and put flat surface led recessed light back up and hit the switch.
HT
Comentado en los Estados Unidos el 1 de marzo de 2018
So frustrating. How hard is it to make a working LED driver! Bought about 15 of these thin LED Lights that game with drivers and within 1 year 8 of them failed due to drivers. Super dangerous, when they were replaced, they were melted and burnt on the outside of the plastic. Very scary and can easily start a fire in your house! In 2 years time bought 8 more drivers and 6 more of them failed. Tried switching companies for the LED drivers this is horrible.. Got 3 of them and all 3 failed! The issue is now I have 10 inch holes in my ceilings and these custom LED lights size so I dont have much of an option to completely replace the entire LED lights due to the constant bad LED drivers.
MNE
Comentado en los Estados Unidos el 28 de junio de 2017
I'm using this to drive an "angel eye" LED ring that I've mounted around the chuck of my drill press.Fit&finish is somewhat poor. The two halves of the enclosure fit together poorly, and the enclosure is much bigger than it needs to be for the circuit board inside. The circuit board is not attached to the enclosure, just held in place by the wires, and moves around when you jiggle the wires. Still, it was just what I needed: a low-Watt LED driver small enough to mount inside my drill press.
Productos recomendados
Mex $983.00
Mex $ 452 .00 Mex $452.00
Mex $8,510.27
Mex $ 1,881 .00 Mex $1,881.00
Mex $249.00
Mex $ 149 .00 Mex $149.00
Mex $1,835.51
Mex $ 807 .00 Mex $807.00