No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Propósito de cinta selladora de butilo
multiusos
Adecuado para varios modelos de coche y otros artículos que requieren pegar o sellar
Visualización de detalles
La molienda coloidal es delicada y tiene alta viscosidad, lo que evita fugas, corrosión y deformación.
Elástico
Fuerte extensibilidad, se puede estirar libremente y rebotar automáticamente, con un fuerte efecto de plasticidad.
No se envejece fácilmente
No es fácil de envejecer, resistente al desgaste
Duradero y duradero.
reefseeker
Comentado en los Estados Unidos el 3 de febrero de 2025
Worked great for sealing up some air space, does NOT smell at all
grant
Comentado en los Estados Unidos el 25 de febrero de 2025
good alternative for if you need thick double sided tape or weatherproofing
Bobg
Comentado en los Estados Unidos el 21 de febrero de 2025
I bought this to seal the windshield in the zenith 750 heavy duty airplane I just finished. This was just the stuff to keep air and water from getting in. I think it’s going to work just fine. I used a razor blade to make the diameter of the roll about half to get it where it needed to go. It seems to have good adhesion to steel and plexiglass, and was very soft and flexible to male installation very easy. I’m flying the time off on the Zenith now. It was a lot of fun to build. Flying the time off means that the faa will let you fly it only 50 miles or so, or carry passengers until you get 20 or 40 hours of flying in, depending on the airplane
Augsburg
Comentado en los Estados Unidos el 5 de octubre de 2024
The 1/4 inch butyl cord I received was good quality and appeared fresh. It was a round cross-section "cord", and not a flat tape. The butyl cord was very flexible and sticky, but not so sticky that it would not let go of your fingers. I applied it at about 70F degrees and kept it out of direct sun so it would not get too soft. I used the cord to seal around the base of some outdoor wall lights that did not fit snuggly to the wall. It worked great. I could push and pull the butyl cord into shape to fit the crack between the light base and the wall. Should provide a good seal from weather.
james j buchanan
Comentado en los Estados Unidos el 17 de septiembre de 2024
1 Choose how long you want it. 2 take off the paper backing. 3 put both hands in a cup of water. 4 with your fingers, push and mold where you want it. 4 If it sticks to your fingers get your fingers wet again. It never dries out so you can correct your mistakes at any time. It could take a long time to do, especially if the job is overhead.
Productos recomendados
Mex $849.78
Mex $ 441 .00 Mex $441.00
Mex $608.17
Mex $ 298 .00 Mex $298.00
Mex $351.80
Mex $ 158 .00 Mex $158.00