Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

CWKJ - Impulsor de rotor de bomba sumergible con eje y rodamiento, impulsor de repuesto para bomba de 400 GPH, filtro magnético de repuesto de 15,5 mm

Envío gratis en pedidos superiores a Mex $600.00

Mex $318.95

Mex $ 153 .00 Mex $153.00

En stock

Acerca de este artículo

  • La pieza de repuesto tiene rotor, eje, rodamiento y tapas finales.
  • El reemplazo directo para el impulsor original garantiza un ajuste perfecto.
  • Es un impulsor de filtro en miniatura, bombas sumergibles en miniatura dedicadas.
  • Fabricado en plástico, metal e imanes.



Nota:
Asegúrate de que el tamaño se ajusta a tu bomba antes de comprar. Es adecuado para bombas CWKJ 400GPH.
Tamaño: 1.3 pulgadas (profundidad) 0.6 pulgadas (largo) 2.6 pulgadas
El paquete incluye:
Rotor de repuesto de 15,5 mm


Malcolm McCorquodale III
Comentado en los Estados Unidos el 21 de marzo de 2025
I received the new part today and replaced the old impeller. Works great. Fit is a little tight, but that's probably a good thing.
fred t.
Comentado en Canadá el 18 de agosto de 2024
Someone missed the mark on this . Does not work in the intex spa
TAB
Comentado en los Estados Unidos el 20 de febrero de 2024
My new impeller arrived with only one bushing. Typically that’s what goes bad. I tried the unit anyways using one of the old bushings as I needed my hot tub up and going. Without the second new bushing the impeller would bind and not spin. Unacceptable but kind of expected these days. If I could give this zero stars I would.
noneya bidness
Comentado en los Estados Unidos el 4 de noviembre de 2023
Shipped very fast which we needed. Brought the inflatable hot tub out of storage and set it up.Once the water level reached the correct level, started heating since it was getting to freezing the next 2 nights.Pump made a bad noice and E02 popped up. Filter was fine, not obstruction in the lines. Used my GoogleFu and the cause might be a bad impeller.Watched videos of the disassembly and found out that the ceramic axle rod was broken.Ordered this one, installed it and worked perfectly. Didn't really notice if it was smaller like some said on here. Heated from 50 water to 104 I'm the correct time. (36hrs give or take).Enjoyed the hot tub yesterday.
Jacqueline B.
Comentado en los Estados Unidos el 27 de mayo de 2021
Fits my saluspa 90427e, fairly close. The impeller width and magnetic shaft width as well as the bearing rod height match what came with the spa. The height of the impeller blades is less, however, so the pump will be less efficient. But... It pushes enough water to pass the flow check sensor. And it's quiet compared to the noise the pump used to make! And it's a ton cheaper than anything else I found.
Productos recomendados

Mex $381.02

Mex $ 175 .00 Mex $175.00

4.4
Elegir

Mex $340.79

Mex $ 170 .00 Mex $170.00

4.7
Elegir

Mex $614.42

Mex $ 282 .00 Mex $282.00

4.9
Elegir