Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Defender Security U 10278, golpe de puerta ajustable chapado en cromo, 2 piezas (paquete de 1)

Envío gratis en pedidos superiores a Mex $600.00

Mex $79.46

Mex $ 41 .00 Mex $41.00

En stock

1.Tamaño:Paquete De 2


Acerca de este artículo

  • Se utiliza como un golpe de puerta ajustable de dos piezas para una variedad de puertas oscilantes
  • Construido a partir de acero estampado y viene en un acabado chapado en cromo
  • Diseñado para adaptarse a sistemas de jamba de acero
  • Todos los accesorios de montaje necesarios están incluidos para una instalación rápida y fácil
  • Para obtener más información dimensional, consulta el dibujo de líneas


Este golpe está fabricado con acero y viene acabado en cromo. Este estilo es ajustable y se adapta a sistemas de jamba de acero. Viene completo con cierres para una instalación rápida y fácil.


Customer
Comentado en Canadá el 13 de marzo de 2024
Big compared to old one but great quality
Sarah H
Comentado en los Estados Unidos el 22 de noviembre de 2024
Good quslity but size wasn’t right for my door
Florida Bob
Comentado en los Estados Unidos el 8 de septiembre de 2024
Worked as described no complaints.
Steve J
Comentado en Canadá el 19 de noviembre de 2023
Had to open up the frame side hole to make room for the receiver, but works well.
C. Stuart Hardwick
Comentado en los Estados Unidos el 6 de noviembre de 2022
This adjustable strike place solves misalignment problems in both directions, up and down and inside to outside.We had a door that never latched smoothly, and after removing and reinstalling it to install a modern bottom seal and new threshold, I could NOT get it to latch, no matter how I futzed with the hinges. The problem was that with the door properly plumbed in the opening, the latch and bolt were too low by so far, the bolt could barely operate and the latch would not engage at all.This adjustable door strike, being taller than the standard strike plate, solved that problem without the need to fill and relocate the old screw holes Because it's taller than the standard strike plate, I only had to use a chisel to enlarge the bottom of the mortise, then install the new plate in the existing upper screw hole and a new lower screw hole--far easier than having to fill the old screw holes with dowel like in the old days.But that's not all. This strike place is in two parts, An outer "clamp plate" that's open on one side and with slotted holes that permit adjustment in the inside to outside direction and are covered by the outer plate. I just had to chisel a bit from the inside of the mortise and adjust the strike plate to permit perfect, secure latching against the additional pressure of the new weatherstripping..
Productos recomendados

Mex $564.42

Mex $ 259 .00 Mex $259.00

4.5
Elegir

Mex $195.00

Mex $ 113 .00 Mex $113.00

4.9
Elegir

Mex $963.55

Mex $ 481 .00 Mex $481.00

4.3
Elegir