No hay artículos en el carro
No hay artículos en el carro Descripción
Ten en cuenta:
El módulo de alto voltaje debe evitar el uso de electricidad en alto voltaje sin carga. (La potencia debe ajustarse a una distancia adecuada a la línea de salida de alto voltaje, la capacidad de la batería es proporcional a la distancia y al uso del arco de alta presión (no es un voltaje lo más alto posible, debes proporcionar suficiente corriente). Prueba experimental de la distancia del arco de corta a larga, no exceda la distancia máxima de arco de electricidad, la energía no se puede liberar debido a la alta presión, puede dañar fácilmente el módulo). )
Trabajo: intermitente, el trabajo continuo no permite más de 1 minuto y el lado de salida no permite cortocircuitos. Voltaje incorrecto y largas horas de trabajo fácilmente dañado módulo
El paquete incluye:
5pcs
Anthony
Comentado en los Estados Unidos el 21 de febrero de 2024
I tested these using a hydrogen spectrum tube as the load it creates is very stable compared to a spark gap. These tubes require only 3-5 kV so the output is obviously nowhere near to 400kV. At 5V in the current draw was close to 4A. It started getting slightly warm after less than a minute - I have not tried running it for longer.
Helenk
Comentado en Canadá el 6 de diciembre de 2024
Works well, have been using this for a couple months as an ignition system for a pulsejet.
Customer
Comentado en los Estados Unidos el 11 de noviembre de 2024
Just testing the first one seems to be working well. 3V in pulled ~9 watts (~2 amps), I put a 5 ohm 10 watt resistor on it so it hopefully won't cook itself.
Nate
Comentado en Canadá el 29 de septiembre de 2023
No se pudo cargar el contenido.
Dennis Mummert
Comentado en los Estados Unidos el 18 de enero de 2022
Major Warning!!! Treat these modules with respect. They will set you on your you know what if you aren't very careful. A *brief* touch to a 9 volt battery will pop out an inch long spark and a loud snap. They are NOT rated for 9 volts, and operating in that range will destroy them quickly. The dielectric properties of insulation are absolute. Exceed it, and it perforates. Period. I marked the module I tested, and plan to discard it. They are also not rated for high current, so include a (high voltage) resistor in your final circuit. Remember that at 400 kilovolts, it only takes a current of 0.0025 milliamps to produce 1 watt of current. And that would probably be about the limit to these, unless someone wants to do some destructive testing. Quarter watt resistors aren't going to do the job, which is why I said HIGH VOLTAGE resistors. If you don't run them continuously, and don't exceed the input voltage constraints, great. Just don't complain when they stop working.
Productos recomendados
Mex $2,028.53
Mex $ 973 .00 Mex $973.00
Mex $296.00
Mex $ 150 .00 Mex $150.00
Mex $5,266.80
Mex $ 1,881 .00 Mex $1,881.00
Mex $216.38
Mex $ 112 .00 Mex $112.00