No hay artículos en el carro
No hay artículos en el carroMás información del producto
Drill America DWRRBSS - Escariadores para puente
Los escariadores de puente de acero de alta velocidad de Drill America se utilizan para alinear los agujeros existentes antes de la instalación de pernos o remaches.
Punto cónico
El punto es cónico para permitir la entrada en agujeros superpuestos.
3-Vástago plano
Tres planos colocados simétricamente en el vástago proporcionan un agarre positivo en herramientas eléctricas y neumáticas portátiles.
Martin
Comentado en Canadá el 18 de abril de 2024
Pour agrandir un trou, c'est idéal
Lucas
Comentado en los Estados Unidos el 13 de julio de 2023
Reamer worked perfectly on 3/8 mild steel but needed a surprising amount of power to run it. Neither 8 amp corded milwaukee or drill press wanted anything to do with it. Old school gear reduced hole hog didn't mind it though. Just had to be careful not to bind the bit and he plenty of lube. Only did 6 holes so i can't comment on longevity.
S. Crosby
Comentado en los Estados Unidos el 15 de octubre de 2023
This thing got the job done. Never used one before. I needed to ream six holes on a power rack and attachments. I didn't know what to expect. I ordered it plus some cutting fluid. (Don't try it without that.) But, it cut through the steel pretty much like butter. Finished the job in five minutes. I'll never need it again and wish that I could sell it to someone.
John Beatty
Comentado en los Estados Unidos el 10 de diciembre de 2022
I had 12 chain sprockets on a 1" shaft that had a through-bolt drilled in. The hole had become worn, so I decided to drill them up from 5/16" to 3/8"and pin them with a steel roll pin. The problem was that everything had to be in alignment, which could not be done on the machine with a conventional drill bit. I thought of a standard reamer, knowing the hardened shaft would trash it quickly. Then these popped up! Not only did it perform flawlessly in alignment, but it drilled out all 12 (cast steel sprockets/hardened shafting) and wanting more! Also, as the spiral is a reverse, it pushes away the chips rather than draw it into the work and jamb it. Every shop should have these!
Aaron
Comentado en Canadá el 30 de junio de 2019
The product I received had been used before as there was a notch in the flutes all the way around. Otherwise it works perfectly. I will buy another
Productos recomendados
Mex $460.53
Mex $ 225 .00 Mex $225.00
Mex $1,090.47
Mex $ 490 .00 Mex $490.00