Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

EDGELEC 100 diodos LED RGB tricolor de 5 mm (rojo, verde, azul multicolor), 4 pines, cátodo común, lente redonda difusa, 29 mm de largo y 300 resistencias (para CC 6-12 V) incluidas, diodos emisores

Envío gratis en pedidos superiores a Mex $600.00

Mex $417.82

Mex $ 188 .00 Mex $188.00

En stock

1.Color:Rojo


2.:3mm Blinking Light


Acerca de este artículo

  • Descripción general del producto: 100 diodos LED + 300 resistencias
  • Características del producto: Luces tricolor (rojo/verde/azul) / cátodo común / lente redonda difusa de 5 mm
  • Parámetros del producto: 29 mm de largo / rojo: DC 2.0-2.2 V; azul y verde: DC 3.0-3.2 V (IF = 20 mA) / 0.06 vatios / 2 pines / DIP LED
  • Parámetros del producto: Luminancia más brillante hasta +20% / Ángulo de visión de 120° / Diodos LED individuales. Peso: 0,38 g
  • Accesorios: 200 resistencias de película metálica de 430 ohmios + 100 piezas de 470 ohmios (para CC 6-12 V) 1/4 vatios incluidas/± 1% de tolerancia



* Bajo consumo de energía y bajo calor.
* Tamaño estándar industrial, plomo de 29 mm de largo para un uso amplio y conveniente para la cperación.
* Condición de soldadura (soldadura manual): menos de 3 segundos con 500 °F a 500 °F
* Condición de soldadura (soldadura por reflujo): menos de 5 segundos con 500 °F.
* Condiciones de almacenamiento: preservación de secado y mantener alejado del fuego o de alta temperatura.
* ¿Tienes otros modelos LED? Busca "Diodos EDGELEC"


Andy A.
Comentado en los Estados Unidos el 3 de enero de 2024
Not sure why, but I was certain that when I originally bought these the middle pin was supposed to be the CATHODE (common or negative), and the outer left or right pin were for the anode (positive) to illuminate the red or green lights (I bought the dual color ones). When I hooked them up, though, it turned out the middle pin was what you connect the POSITIVE wire too. I'm fairly new to small electronics and LED lights, so I'm going to say the fault was my own.DO NOT use these without a resistor (you need a resistor on each outer pin). Do NOT put more than 5V through it WITH the resistor. The green lights did fine, but I blew out the red side on 4 or 5 of them before I realized my mistake. The green side still works, so they're not totally useless.Using these for flight simulator panels. They work really well and seem to be pretty consistent in size. You get a LOT of them for a few bucks, so I'm flush for now. If I needed more, though, I would happily buy them again!
Isabelle
Comentado en Canadá el 31 de diciembre de 2023
Tel que décrit. Bon rapport qualité prix. Arrivée rapidement.
PANCHO FAJARDO
Comentado en México el 10 de enero de 2023
Muy ligero y duradero alusa muy fuerte y claro.Cumoke al 100 con todo..Saludos desde monterrey nuevo leon
Salhidaus
Comentado en México el 2 de julio de 2022
Justo lo que necesitaba
Gaëtan rochon
Comentado en Canadá el 18 de mayo de 2021
Pour ajouter à vos RC du réalisme beau bon pas cher sur que c'est plus long que d'acheter des kits tout faits mais tellement moins cher que ça vaut la peine tous mes rc sont équipées de lumières de ce genre et je suis très satisfait du rendement et de la durabilité je vous les conseils fortement le range de 3v a14v est idéal demande un peu d'équipements dextérité et patience mais un coup fini le résultat est très satisfaisant.
Jordan
Comentado en Canadá el 16 de septiembre de 2020
Exactly what I ordered. It is nice to have LED's come with their respective resistors. The LED's blue LED's are what I ordered and they are nice and bright using an 18650, 4000mAh 3.7V battery.
Big Orange Wookie
Comentado en los Estados Unidos el 3 de diciembre de 2018
Summary - Nice pack of LEDs to repair Christmas lightsPros- Common colors, good for Christmas lights- 20 of each color- Good priceCons- Base of light is wider than the light, so it doesn't sit down in the Christmas light baseI used these to repair burned-out LEDs on several strands of C9 Christmas lights. I like the color choices, as they are common to most Christmas light strands. Mine are red, orange, yellow, green, and blue. This pack contains 20 of each of these colors along with 20 white and 2 packs of resistors which is a nice bonus feature (but not useful for repairing my Christmas lights).These function very well, my only minor complaint is that they do not sit snug down in the holder for the LED like the original ones. They do stay in place relatively well once you bend the wires around the base.Speaking of wires, they have a very long wires so once you bend them in place, you will need to snip off the excess. But... Make sure you don't snip off too much or the LED will not have proper contact and won't light (I found this out the hard way).These are very bright and the colors are true. I'll be buying them again.Overall I am very happy with this purchase. If this helped you, please consider giving it a thumbs up. Thank you.
Productos recomendados

Mex $4,163.76

Mex $ 1,748 .00 Mex $1,748.00

4.6
Elegir