No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Controlador de presión de bomba de agua automático EPC 4 110V 10A Control de interruptor electrónico Control de prensa de bomba IP65 10bar
1 a 1,5 bar: la presión de arranque es de 1 a 1,5 bar, y la presión máxima de trabajo puede ser de hasta 10 bar
Comprueba la presión: el manómetro comprueba el valor de la presión de arranque y la presión en el.
Funcionamiento de protección: Parada de la bomba cuando detecta falta de flujo de agua, evitando daños en el funcionamiento en seco
Paulino
Comentado en México el 5 de mayo de 2024
Funciona perfectamente
Clifford Guay
Comentado en Canadá el 22 de octubre de 2021
Not well packed arrived the unit looked used. Upon taking the unit out you could here stuff rattling inside. I opened the unit up and had to put all the components together. Once put together and installed the unit kept going into fault and kept having to press the reset button. I re-opened the unit, took it all appart again. I took a look at the spring and realized that it was too big for the application i needed it for. Replaced the spring and voila!!! Working. I will report back after its intended use. Beware cheap cheap cheap plastic. Do not ovwrtight the screws.
Serge Bernard
Comentado en Canadá el 20 de septiembre de 2019
I can't speak to durability as I just installed this product, but it is performing really well as far as controlling the pump and keeping the pressure. Time will tell... Well, time did tell. I'm updating because in less that 2 weeks it started acting up where the pump would run on to the point where it almost burned up my pump, I caught it just in time. I tried turning the pressure setting to the minimum but it was the same. I had to take it out. Took a chance, wasted my money.
Productos recomendados
Mex $3,590.00
Mex $ 1,471 .00 Mex $1,471.00
Mex $3,999.00
Mex $ 1,799 .00 Mex $1,799.00
Mex $5,238.00
Mex $ 1,881 .00 Mex $1,881.00