No hay artículos en el carro
No hay artículos en el carroEverflow 60x10mm High Speed 12V 3 wire 3 pin # R126010BU The Cooljag Everflow 60 x 10mm Fan mounts on standard 60mm fan holes. Low profile with a thin 10mm width and 3pin standard connector. Specifications Model: R126010BU Dimensions: 60x60x10mm Bearing: Ball Rated Voltage: 12V Operating Voltage Range: 7 ~ 13.2V Rated Current: 0.35A Rated Input Power: 4.2W Rated Speed: 5200 RPM Max Air Flow: 19.41 CFM 0.41 m^3/min Max Static Pressure: 1.81 mmH2O Sound Level: 37 dBA Connector 3Pin /3Wire w/ 8 inch tail Housing Material: UL 94V-O Plastic Impeller Material: UL 94V-O Plastic Protection: Current Limit / Impedance Operating Temp: -10 - 70°C
jomagara
Comentado en los Estados Unidos el 2 de marzo de 2022
Compre varios ventiladores, y uno de ellos venia con dimensiones diferentes a los demas.
Sam
Comentado en los Estados Unidos el 25 de abril de 2021
It's much quieter than the failed fan I replaced with it. Maybe too quiet as it doesn't draw anywhere near 0.35A. Air is moving and the power supply isn't getting hot so I guess it's doing it's job. I was really expecting a bit more of it with the advertised power ratings though.
BEarl
Comentado en los Estados Unidos el 28 de abril de 2020
I used this to replace the fan on my NAS when it failed. This fan is SIGNIFICANTLY noisier than the original. In addition, it does not seem to drop into a low speed mode properly (although I am not sure if this is due to the fan or the controller). It constantly revs from up and down when the NAS is idle. I do not think this fan is going to last very long as it is not intended to run continually as it is and the revving up and down will take a quick toll.
Productos recomendados