No hay artículos en el carro
No hay artículos en el carroFOXBC Cabezal de corte helicoidal en espiral para cepilladoras DeWalt DW735 DW735X
tech2ww
Comentado en los Estados Unidos el 7 de enero de 2025
The bottom line is that this cutter produces a great quality surface that needs at most a final sanding before finish. Also creates much less load on the motor, less load on the drive rollers (therefore almost no snipe), less noise (but still noisy). Essentially you get a new level of tool.The installation requires significant disassembly of the planer, plan on hours not days. This is unavoidable but the instructions are clear with only a few mistakes that are not consequential, and the provided photos are plentiful.Installation notes, in no particular order:Use quality ring pliers (very stable) that don't have interchangeable heads (which aren't).The cutter head lock will be discarded.Wood is not strong enough to hammer the bearings into place.When the instruction say "wedge a board tightly" it really means place an approx 1/2" thick board to the side of the roller to jam and prevent rotation when you are loosening/tightening the roller.The gear box doesn't have to come out all the way, so just let it dangle from the speed control shaft.A cap head screw is referenced but is not included but the alternatives are obvious and work fine.The roller doesn't fit into the chassis with the cutters installed. Installing cutters needs to come later and is not mentioned in the instructions, is done after the roller is in place. Careful not to drop a cutter past the roller into the bottom of the chassis.Carefully seat each cutter, else you start to tighten with it out of line and not fully supported (carbide is very brittle).Torque for the cutters is 30 in-lb. Use a torque driver, don't guess.The roller comes in shipping grease of some kind, so wipe it down (at least) and you won't get much of a mess when you first run it.
A Smith
Comentado en los Estados Unidos el 15 de enero de 2025
Happy with the quality of it and the cuts are super smooth. Installation wasn't hard just took a little bit of time. Definitely recommend.
Nigel i.
Comentado en los Estados Unidos el 10 de junio de 2024
Works great! Get on YouTube to find directions if this feels overwhelming. So happy with the results.
Not available
Comentado en los Estados Unidos el 11 de diciembre de 2024
I installed this in my 20 year old Dewalt 733. I had contemplated getting a whole new planer, but decided to give this a try instead. The cutter head is nicely made, you have to disassemble most of the machine to install it and there are no instructions, but it's relatively easy and there are videos on you tube. With the new cutter installed, the finish is outstanding, no snipe or tear out whatsoever.
Bantario
Comentado en Canadá el 30 de septiembre de 2023
Works great, no lines and almost zero snipe. lets hope the blades last
Productos recomendados
Mex $479.00
Mex $ 225 .00 Mex $225.00
Mex $466.60
Mex $ 223 .00 Mex $223.00