No hay artículos en el carro
No hay artículos en el carro El producto incluye:
1 mandril 6-32.
1 mandril 8-32.
1 mandril 10-32.
30 tuercas de remache.
R. A.
Comentado en los Estados Unidos el 24 de marzo de 2025
Purchased extra mandrels in case I broke one. So far they have held up well with no problems.
Customer
Comentado en los Estados Unidos el 3 de febrero de 2025
They are very good material and look like they will work nicely
Robert M.
Comentado en los Estados Unidos el 6 de enero de 2025
To a function exactly the way it should was able to repair several units with this with no problems
Jesse Winkler
Comentado en los Estados Unidos el 18 de enero de 2025
Theres literally a spot in the case for holding these 3 additional mandrels, WHY WHY WHY were they sold separately?! The holder for the rivnuts themselves even has a place for these sizes!! As described but ridiculous it's seperate!!
J. Street
Comentado en los Estados Unidos el 24 de marzo de 2024
About the Giantisan rivnutter, and it came with a good assortment of mandrel/setters. It States both in the manual and on a sticker prominently added inside the tool kit casing that these three mandrels have to be ordered separately, and I found out why. The hard way.If you are using these mandrels, they are smaller, and more delicate than what comes in the main toolkit. Therefore, you can't really crimp by feel on these.. you have to really pay attention to the linear stroke on the gauge built into the tool.If you don't set it up and calibrate the stroke correctly, you can break the tiny little 6-32 mandrel as I did. I have also considered that it could be poor metallurgy, but it's more fair to say that it was most likely my own mistake instead. The Dual handle rivet setting tool is a real hoss, and I could easily see why it overpowered the tiny little 6-32 thread gauge on this mandrel due to poor calibration.I was only 7 rivets into a ~300 rivet project!Fortunately, there is another store on Amazon that offers a pair of 6-32 mandrels that fit this tool for a fair price, so I did not have to purchase this entire three mandrel set again.I have received the new replacement pair of 6-32s, but have not been able to return to the project yet. I will soon though, so I will add an update here if necessary!Take heed, and fully read the manual of the rivetting tool before setting up these mandrels. I can't emphasize that enough.I do not fault Giantisan for my troubles, just my own ignorance. But I'm learning!
Productos recomendados
Mex $382.40
Mex $ 202 .00 Mex $202.00
Mex $6,292.00
Mex $ 1,881 .00 Mex $1,881.00
Mex $1,026.00
Mex $ 533 .00 Mex $533.00
Mex $1,729.00
Mex $ 829 .00 Mex $829.00