Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

GTINTHEBOX - Reflectores ópticos 3D para parachoques trasero, luces traseras de freno y luces de señal de giro secuencial para Toyota Camry 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2024, lente roja

Envío gratis en pedidos superiores a Mex $600.00

Mex $724.68

Mex $ 347 .00 Mex $347.00

En stock

Acerca de este artículo

  • ❶ Compatible con Toyota Camry 2018, 2019, 2020, 2021, 2022, 2023, 2024 como reflectores de parachoques trasero, luces traseras de freno con modelo de luz de señal de flash de Chase secuencial
  • Ajuste exacto y reemplazo directo: reemplaza el reflector rojo y funciona como luz de freno adicional, luces traseras y luces intermitentes
  • Conecta el cable azul a la luz de freno negativa, el cable verde a la luz trasera positiva y el cable rojo a la luz de freno positiva, el cable amarillo para girar la señal positiva
  • Ajuste exacto y reemplazo directo, los LED superbrillantes tienen un tiempo de respuesta de encendido/apagado más rápido para la seguridad de conducción y el diseño perfecto mejora el aspecto exterior de tu coche.
  • Impermeable IP65, a prueba de golpes, a prueba de polvo, más de 50.000 horas de vida útil.


Marca: GTINTHEBOX
Características:
► Lente roja.
► 1 par (izquierda y derecha).
► Fabricado con luces LED LED de color rojo brillante 3D.
► Puede reemplazar el reflector rojo y funcionar como luz de freno adicional, luz trasera y luz de señal de flash secuencial
► Viene con modelo de luz trasera/luz de freno para mejorar la seguridad en la calle.
► Ajuste exacto y reemplazo directo.
Compatibilidad:
✔️ Para Toyota Camry 2018, 2019, 2020, 2021, 2022, 2023, 2024.
Instalación:
→ Todas nuestras bombillas LED están diseñadas para una fácil instalación y reemplazo directo.
→ Conecta el cable azul a la luz de freno negativa, el cable verde a la luz trasera positiva y el cable rojo a la luz de freno positiva, el cable amarillo para girar la señal positiva


Desiree Tejada
Comentado en los Estados Unidos el 13 de marzo de 2025
Le quedo muy bien al carro
Dan S
Comentado en los Estados Unidos el 16 de enero de 2023
21 Camry xseWas very iffy on getting these.. Most ALL aftermarket is junk.Purchased these after lots or research and I have to say I’m very pleased with them.Instal?Bumper does NOT!! Have to come off, get under the bumper and look for the silver screw with a pink paint spot on it..I used a 90 Deg screw driver(any local tool sells them) grabbed a few different length bits and configured them to reach up and around the muffler and rear bumper support and the screws came right out.Next, align the light up and look where the wire comes out of the light to the bumper and drill a hole for the wires to go threw..Make the hole bigger then the wires so you have extra room as to NOT pinch the wires.Check alignment and run the wire threw and pop the led in.Here is the tricky part, hold the led with one hand while reaching up with the other, screw in hand and start tightening the screw.. then grab your screw driver and tighten.This isn’t hard just tricky..Next grab a pick tool or a small screwdriver and tape the led wires to it with electrical tap and push it threw the big rubber grommet..This is the same for both sides… after you have done both side next pull the plastic trunk cover off and you will see a white clip with 4 wires in it..These clips are in the same spot on each side and have different colored wires…You will need a probe to find what wire does what..DONT JUST START STABBING WIRES WITH THE LIGHT PROBE!! Only the clip with the 4 wires in it.. clip will have A ground,blinker,parking and brake..Ok so if you made it this far you will now be able to enjoy the new led lights..They do have a little bit more thickness then the reflector so expect that and other then that I’m very happy with the fit and finish and they are bright and work as they should..If they fail with in 30 day I will update here..Hope this helped someone..
Samuel G
Comentado en los Estados Unidos el 7 de julio de 2022
The sequential turn signal is really cool when you brake or have you’re turn signal. Very bright. Careful removing youre bumper!
Mulafer Hazar
Comentado en los Estados Unidos el 3 de octubre de 2022
Instructions were in the Box Lid, Identifying all four wires, Bumper removal was easy, watch Youtube, used rear tail light harness to tap wires, only opened small section of insulation, identified car wiring harness by stepping on brakes, turning on lights & signals, Can be used for any or some of those features, The Lights are a perfect fit Be sure to tape all exposed wires very tight and some tie-wraps/zip ties to keep it from dangling. Need to drill 2 holes through the spare tire bay on each side to feed the wires and apply silicone to make it moisture tight at the holes. It took me an hour to complete installation, The Lights really stand out.
kevin
Comentado en los Estados Unidos el 8 de septiembre de 2022
takes some effort to install, remove the bumper, drill a hole and pass it through. But it makes the back of the car look better, do it if that's what you want. Nice and bright, and sequential. XSE Camry 2020 is my car and fits fine without any problem.
Productos recomendados

Mex $1,289.00

Mex $ 644 .00 Mex $644.00

4.9
Elegir

Mex $250.00

Mex $ 130 .00 Mex $130.00

4.8
Elegir

Mex $243.84

Mex $ 129 .00 Mex $129.00

4.9
Elegir