No hay artículos en el carro
No hay artículos en el carroJacob B.
Comentado en los Estados Unidos el 6 de noviembre de 2024
Fit my bridgeport j head fine it requires drilling and tapping 2 holes in the base casting to mount it which shouldn't be an issue for anyone purchasing one of these. Feels a little cheaply made(I believe its cast aluminum) but it has been holding up fine so far. As long as you don't overload it with extra stuff I don't expect it to break. Its been holding a whole set of collets, a annular cutter adapter, and a keyless drill bit chuck for close to a year now with no issues
Larry
Comentado en los Estados Unidos el 3 de noviembre de 2023
Not anodized as picture shows. Cheap flat black paint easily scratched.
P. Sullivan
Comentado en los Estados Unidos el 22 de noviembre de 2022
I needed a collet holder, and I was going to make one from scratch. When I saw the price on this unit, SOLD! To be fair, I did have to machine the mounting surfaces, 2 of them, so it sat on the Bridgeport body, but as a machinist, that was simple. It mounts up nicely, holds my most used collets, PERFECT!
Jason N.
Comentado en los Estados Unidos el 16 de agosto de 2021
This little ditty is not too bad, but its not perfect either. The feet the mount it need to be massaged to mate up cleanly to the surface of a mill stand. This should not be needed due to the fact that any mill that is not a Bridgeport is a copy of a Bridgeport. It should be design intent that it mount directly to the mill stand, but you can massage it with a grinder, or a boring head if you have the time and gumption.
Tina
Comentado en los Estados Unidos el 12 de mayo de 2016
Works great
Productos recomendados