No hay artículos en el carro
No hay artículos en el carroHerramienta profesional de alta precisión. La base de medición de profundidad permite la conversión de un calibrador estándar a un medidor de profundidad. Se fija a la parte inferior de las pinzas para ayudar a medir la profundidad. Su tuerca de bloqueo asegura la base al calibrador. Hecho de acero inoxidable, de alta precisión y endurecido fácilmente con perilla de tornillo. Sin modificaciones en el calibrador. Permite utilizar un calibrador estándar como un medidor de profundidad que acomoda cuchillas de hasta 16 mm de ancho total de 2,93 pulgadas.
Shannon R.
Comentado en los Estados Unidos el 11 de abril de 2024
Love it. It's perfect. Great price
Zebryk
Comentado en los Estados Unidos el 28 de agosto de 2022
Adds stability to depth measurements which the basic calipers were not designed for. The butt end of these are not flat and rock side-to-side. This very inexpensive "foot" greatly extends the utility of any quality caliper creating a high quality depth guage.
Charles B.
Comentado en los Estados Unidos el 11 de febrero de 2022
This gizmo is something I was planning on making myself so it's good to have one available at a decent price. I was a bit worried about the reviews that stated that the thing would not properly align with the caliper rails and/or would fall off the calipers, but I was prepared to machine it if needed- it was the ground square surfaces that I wanted. On getting it, I found that the reviews were correct, but for the wrong reason. It is a simple error in a part- some doofus spec'd the tightening screw with a cheapo non-square and concave end, to save about $0.0000001. That results in the screw camming out the caliper rail, so there was no hope of it working. Just remove the screw, square the end up a little with a file, and then round the end so the contact is in the middle (axis of rotation). Works fine now.
Mario
Comentado en Canadá el 11 de septiembre de 2021
A bit loose but works.
Jim In Idaho
Comentado en los Estados Unidos el 30 de junio de 2020
To get it done I took a piece of 1/4" steel plate and put two holes in it so I could bolt it to the housing to give me a stable platform to measure from. Using my dial caliper I used the depth side to take the measurement using this to give the caliper stability on the plate. Worked like a charm! Gave me the reading I wanted, make the necessary adjustment with shims and done and back on the track. If you done have hundreds of dollars for the professional pinion depth gauge tools, this will work very well.
Productos recomendados
Mex $833.45
Mex $ 441 .00 Mex $441.00
Mex $261.46
Mex $ 135 .00 Mex $135.00
Mex $477.49
Mex $ 233 .00 Mex $233.00
Mex $4,630.00
Mex $ 1,881 .00 Mex $1,881.00