No hay artículos en el carro
No hay artículos en el carroMás información del producto
Vincent L.
Comentado en Canadá el 17 de octubre de 2022
Can only install in one location in a 3way configuration. Not clear in thr description.
Walt
Comentado en los Estados Unidos el 25 de septiembre de 2022
There is no reason to pay this much for a basic motion switch. This lutron product DOES NOT work with the internet and will do nothing when attempting to add to a lutron hub. If you want a motion activated dumb switch, you can pay a lot for this one or pay a lot less for any other switch on this site because they are all identical. This is overpriced for no reason.
Bauhinia
Comentado en los Estados Unidos el 30 de abril de 2021
I had two in-wall light switches that I wanted to replace with motion sensing switches. Turns out that I didn't have a white neutral wire available and the selection out there is scarce. One model from Leviton and one from Lutron. Aesthetically, I think the Lutron is a little nicer.One quibble I have is that the documentation, while it is very good, could be improved slightly especially in the notes on troubleshooting. I will also post a Question and Answer for this product as I think it may help some other customers in the predicament I found myself in last night.I have a 3-way set up (2 switch locations). So I needed to hook up all the colored wires of the Lutron switch. The wires that run out of the Lutron have two that are black. They are not labeled. But the idea is that one goes to your load/live (e.g. the light fixture/breaker panel) and the other hooks up to one of the "traveller" wires that runs to your other light switch. Well I hooked everything up and (almost) everything seemed to work fine. I could turn off or on the light if the other switch turned on or off the light respectively. However, the Lutron switch would not time-out and turn off the light after the time out elapsed, even though the motion detector turned on the light. The troubleshooting guide is too scant on possible problems and I saw no mention of this on this on the Internet. My a-ha moment came when I considered just swapping the two black wires on the Lutron switch. (Note that the Lutron manual says you can swap the traveller wires if one switch is not toggling the light that the other switch just toggled, but again this is not related to a time-out fail.) Well this did the trick!
Adam M.
Comentado en los Estados Unidos el 1 de diciembre de 2018
Have installed these in 2 separate houses and love them! Love the different colors as well. Easy to program, I install them in areas where I am passing through so that I don't have to flip switches.
Gary
Comentado en los Estados Unidos el 6 de noviembre de 2016
Great product. Easy to install and program. Motion seance is almost instant.
Productos recomendados
Mex $1,767.68
Mex $ 777 .00 Mex $777.00
Mex $933.59
Mex $ 504 .00 Mex $504.00