No hay artículos en el carro
No hay artículos en el carro Interruptor rotativo 4 posiciones 3 velocidades 16A-125V 12A-250V Ventilador selector de velocidad del calentador
Posición 1:
B - C OFF
B - L OFF
B - M OFF
B - H OFF
Posición 2:
B - C - L ON
B - M OFF
B - H OFF
Posición 3:
B - C - M ON
B - L OFF
B - H OFF
Posición 4:
B - C - H ON
B - L OFF
B - M OFF
Maintenance man
Comentado en los Estados Unidos el 12 de junio de 2023
The wire terminals were a for a larger guage wire than my Patton fan had.
Steve Whitson
Comentado en los Estados Unidos el 25 de mayo de 2023
I love the multi-pack of switches!
Sunny
Comentado en los Estados Unidos el 21 de mayo de 2023
The control circuit went bad on my Hunter ($300) air purifier. I used this switch to replace that board and it works fine. Had to drill a hole in the case of the purifier. Not a big deal. Of course it totally manual now which is ok.
Voakley1
Comentado en los Estados Unidos el 10 de octubre de 2022
The switch works fantastic. I'm very happy with it. Runs my fan like a champ.
Dan Stinehelfer
Comentado en los Estados Unidos el 26 de abril de 2022
When I tested the circuit on this switch, the first position is Off, second position B-C and L are connected hot, This will be a dead short in the switch! You can not connect the "C" common to the "B" positive power lead, it is a dead short. The schematic in the drawing looks like it was made in 1965. To use this in a 120V ac 3 speed switch , you must bypass the terminal "C" and go direct to the motor common. Insulate the "C" terminal as it will be hot at all other setting for speed controls. In the first position it is off, "B" to "C" terminals are disconnected. Maybe this is an issue internal design, but it needs reviewed at the MFG. As for as the quality of the switch, it seems good and positive switch spring pressure. I would not know if is really copper inside, but to tear it apart.
Productos recomendados