No hay artículos en el carro
No hay artículos en el carroCartucho de repuesto Mayfair 1000 de repuesto. Características Totalmente sumergible Protegido por ignición 12 voltios Disponible en operación automática o manual Sellos de borde de compresión Puertos de descarga Dura-Port Descarga de 3/4 pulgadas solo 100% probado en fábrica Protección Anti-Airlock Cumple y supera las especificaciones NMMA, ABYC, ISO 8849, CE y USCG Tres año de garantía.
Mike S
Comentado en los Estados Unidos el 20 de agosto de 2024
Works great, nice and quiet
Customer
Comentado en Canadá el 10 de junio de 2024
Works good
mike cork
Comentado en los Estados Unidos el 2 de septiembre de 2024
Plug and play, just wire it in plug into the base unit and you're good to go. Super easy.
Hydroguy8
Comentado en Canadá el 29 de julio de 2023
These Johson pumps are great. Once mounted, should they fail, the cartridge are a simple twist out + unplug. My 2008 Lund bilge pump was intermittent + weak. Picked up the 1000gph to replace it. Perfect fit, crimped on 2 connectors, twisted the old out + new in, done. 100%!!
Bill
Comentado en los Estados Unidos el 19 de julio de 2014
Great product. The old ones I replaced were over 12 years old and used exclusively in salt water. They would have likely lasted longer, but over the winter the drain plug hole got blocked with debris and the bilge pumps cracked from the ice buildup. Replacement is a easy task. I used wire nuts and sealed them from exposure/moisture with "Goop." Plus, I added a wire ties about an inch back on the two leads for added security so that the wire could not be easily pulled apart and would remain secure. I also mounted the wire leads from the cartridge motor as high as the leads would allow. There was plenty of wire on the new Johnson pump leads with the new cartridge. I would recommend that the manufacture list the length in their advertisement because it was a concern of mine but turned out to be of sufficient length. When removing the old pump cartridge, I cut the wire off right at the cartridge, thus assuring much more wire then the original installation. One of the bilge pumps was mounted under the motor, but technically, it's the right location. The 1000 gph motor is powerful and easily lifts the water in the bilges for discharge. No messing with new mounting, hoses, etc. The Johnson bilge design makes the job easy. Highly recommended product replacement.
Productos recomendados
Mex $6,396.51
Mex $ 1,881 .00 Mex $1,881.00
Mex $837.57
Mex $ 435 .00 Mex $435.00
Mex $621.00
Mex $ 316 .00 Mex $316.00
Mex $1,711.71
Mex $ 684 .00 Mex $684.00
Mex $492.32
Mex $ 265 .00 Mex $265.00