No hay artículos en el carro
No hay artículos en el carroDescripción del producto
KAKA Industrial Fb-4 - Freno de doblado de acero manual de 4 pulgadas
El freno de flexión de acero se utiliza para doblar a presión hierro ornamental, acero suave, aluminio y otros metales. Un beneficio de este doblador de acero es que se monta fácilmente en cualquier parte superior de banco. Para la formación en frío de acero y metales, este freno doblador incluye placa de configuración para sujeción de mesa. Además, esta dobladora de chapa se puede doblar a 90 grados simplemente girando el nivel del mango hasta que se logre el ángulo deseado. En general, es una gran herramienta de flexión y frenado para cualquier tienda de fabricación de chapa metálica
Frank T
Comentado en los Estados Unidos el 14 de junio de 2024
This tool works and its well made.
SK
Comentado en los Estados Unidos el 29 de septiembre de 2024
Used for 3/8 aluminum rod worked well
A
Comentado en Canadá el 11 de marzo de 2020
Can’t go wrong with the price! So if people complain don’t listen. The unit works well and like every tool you need to learn it, it has a lot of moving parts but once you figure it out it’s fast. The bends have a much bigger radius than a sharp shop press brake but the tool it’s also 100 bucks not thousands for a proper press. I was bending some 1/8 steel brackets and I deducted 1/4” from each side or 1/2” overall and I got the exact inside measurement I was looking for. See attach pictures, I also show a bracket with a corner bent by a proper press brake and a corner bent by the kaka steel bender. You can compare. This is a great tools for small on the fly parts.
Greg H.
Comentado en Canadá el 1 de marzo de 2019
It's not a bad machine but the male die has a very round Edge so you're not going to get a sharp bend on anything. The edge is about a 3/8 radius, not a point and the female side of the die is quite rounded also. Unless you're trying for large radius bend, I wouldn't use this on anything less than 1/4 inch thick.
Dale
Comentado en Canadá el 29 de septiembre de 2018
I bought this tool to form a number of brackets for a go kart project. It works like a charm on everything I've thrown at it up to and including 1/4 inch by 1 inch steel bars. While there is some slight marking of the bent steel's surfaces, it's a lot less than I've seen on commercially produced parts. This is one of those tools that you'll wonder how you got along without it before using one. Highly recommended.
Productos recomendados
Mex $5,150.00
Mex $ 1,881 .00 Mex $1,881.00
Mex $3,446.93
Mex $ 1,551 .00 Mex $1,551.00
Mex $239.00
Mex $ 131 .00 Mex $131.00
Mex $6,155.31
Mex $ 1,881 .00 Mex $1,881.00