No hay artículos en el carro
No hay artículos en el carroUna manera rápida, fácil y asequible de reemplazar una carcasa o carcasa de llave a distancia sin llave agrietada o desgastada. Reemplace la carcasa exterior o la carcasa en lugar de todo el conjunto con este producto. La instalación es sencilla y no requiere reprogramación. No incluye electrónica ni placa de circuito. Debe transferir sus componentes originales a este caso.
William Fanelli
Comentado en los Estados Unidos el 27 de marzo de 2024
Easy to use, Just remove controller from your old one and install in new cover and you have a brand new Key Fob!
W. Newberry
Comentado en los Estados Unidos el 12 de mayo de 2019
On my old remote I had to press the unlock button hard at least 10-15 times to get it to unlock. So I changed the batteries and still same problem. I found my other old remote , same issue . I changed batteries thinking I had purchased the wrong size. Still both remotes worked horribly. Sticky , worn out old buttons. So I purchased this case which just lets you remove the internal circuit board and battery and you swap them into the new case and OMG !!! It's like I have a brand new OEM remote now. One simple press and the car unlocks . Works like a factory new remote now. Probably the best $6-7 I've ever spent on my car.Seriously if you think your internal circuit board is still good , try this case out , it works perfect.All you do is get a penny and find the groove on your old remote , it's by the part where you put a key ring through the hole. You'll see a little place where you can insert the edge of a penny . Simply twist the penny and crack open the old remote , remove the circuit board out of the jelly button mold , it comes out all in one piece and slap it in the new button mold , snap together the new remote , walk out to your car and see the results.My results were perfect , the car opens now with one simple press of the unlock button.So if you think the internals of your old remote are good , try out this cheap option.
tchr1st
Comentado en los Estados Unidos el 5 de octubre de 2016
This worked perfectly for my 2003 Yukon. Today however, 4+ months later, it broke. Thought it was the battery, but it is a tiny part that is broken off inside. Nothing that could be prevented I'm sure. Will purchase it again!
S
Comentado en los Estados Unidos el 4 de julio de 2015
Replaced mine today. Just like OEM in quality, perfect fit and finish. You can't tell the difference between the stock one and this unit. Highly recommended, works well, great value.
Brad Karmason
Comentado en Canadá el 8 de octubre de 2015
Not quite the same as the factory one in its operation, but it could possibly just need to be broken in. Overall though, far better solution than the expensive OEM replacement.
Productos recomendados