No hay artículos en el carro
No hay artículos en el carro
2 - 6 pulgadas; #11 (4 pulgadas); #10 (3.8 pulgadas); #9 (3.6 pulgadas); #8 (3.2 pulgadas); #6 (3.8 pulgadas); #4 (2.6 pulgadas); #3 (6.1 pulgadas); cm (2.2 pulgadas); #1 (2 pulgadas); conectores de 2 pulgadas; cilindro de 10 pulgadas.
* El juego de calibradores viene en su propia funda de transporte.
Nota: Ningún producto para dos ranuras es correcto.
William Master ASE, PPSEL, A&P
Comentado en los Estados Unidos el 19 de marzo de 2025
Find this to be very useful. Works well for my limited used checking behind the machine shop. Already saved me from improperly sized rods after ARP rod bolt replacement.
Phillip Martin
Comentado en los Estados Unidos el 20 de enero de 2025
Pretty inexpensive so I wasn’t expecting much. Out of the box it doesn’t operate smoothly. If you break it down and polish the linkages it’ll work flawlessly.
Mark cody
Comentado en los Estados Unidos el 15 de enero de 2025
great tool and great price
Customer
Comentado en Canadá el 13 de agosto de 2023
The bore gauge contact point sticks and will not move without being pushed back by the indicator. Completely unfit for purpose. Do yourself a favor and buy a higher end one. This one is completely unusable.
Customer
Comentado en los Estados Unidos el 12 de enero de 2020
This was simple to use and there are plenty of videos online to give you the basics. Be careful to keep track of the small spacers. Take your time accurately setting zero for the cylinder specifications of the cylinders you are measuring and then this tool can quickly be move around to different positions in the cylinders. You need an accurate outside micrometer to set the dial to zero. A simple inside micrometer can be use to measure cylinders but this is easier and faster. I used the bore gauge an inside micrometer an outside micrometer and a digital caliper against each other. For the cost this tool is accurate has a decent case and will do the job. I use it to make decisions prior to committing to have machine work performed on cylinder blocks not as a replacement for measurements and inspection taken at the machine shop.
Productos recomendados