No hay artículos en el carro
No hay artículos en el carroMarinca Power Products 50 Amp Locking Devices are designed for fast and easy assembly, while providing highquality features that enhance versatility, safety, and durability. Rear housing key fits into the front portion for ease of assembly. A stainless plug sleeve provides greater strength and protection. A nonmetallic shell around the plug sleeve eliminates exposed metal parts. Other features include an adjustable cord clamp for superior strain relief, recessed cord clamp screws for a neat, clean appearance, exclusive perma PermaLock terminals for secure, easytowire connections, thickwalled nylon housing that resists abuse, corrosion, and most chemicals, and a neoprene dust seal to keep contaminants out of the wiring chamber. .
FlyBoyMark
Comentado en los Estados Unidos el 29 de agosto de 2023
The set screw stirrups that hold the wire are extremely flimsy and made from sheet metal and folded over with the set screw running through instead of being one piece of heavy metal. When torquing the set screws down the stirrups deform and strip. Rivet that holds the physical ground strip on the side is too big and will not allow the plug to go in and twist and lock. I had to remove it and put in a 440 flathead stainless screw with a nylon lock nut on the outside. The average Joe that tries to install this is going to be very frustrated because of these issues. This item should be pulled from Amazon, it's junk. This is why Hubble gets almost a hundred bucks for this type of receptacle.
GAL Power
Comentado en Canadá el 13 de marzo de 2023
As advertised.
Isaac D.
Comentado en los Estados Unidos el 4 de febrero de 2021
Installed this into a panel for a 50 amp generator inlet. Wired it with #6 thhn. Tightened up with no problems. Does not seem quite as solid as the more expensive brands but is going to work just fine for my occasional usage. Good product for the money.
Productos recomendados