No hay artículos en el carro
No hay artículos en el carroEl soporte perfecto para escaleras, madera, tuberías, equipos deportivos y otros materiales largos.
Corey Bryant
Comentado en los Estados Unidos el 19 de mayo de 2023
Easy to install and the mount design will conform to most beds. Drill 6 holes, and you're done. It's sturdy, and doesn't squeak or rattle. It's solid. I've been using mine for over a year and no issues. I strongly suggest using larger and THICKER washers under the nuts, because they will rip right through the sheetmetal! I ended up cutting out a couple of 2mm steel rectangles to go behind the sheetmetal. The washers they include are too thin and just bend.
Eugenio Biebrich
Comentado en México el 9 de diciembre de 2023
muy bien, tiene dimensiones para Ajustes, excelente calidad de material
T.C
Comentado en los Estados Unidos el 23 de marzo de 2021
Racks were simple enough to install. They came with a couple basic diagrams describing how everything goes together, not step by step instructions.I added a few thin pieces of steel behind the mounting hardware to spread the load of the bolts. A large washer would also accomplish this if you are worried about the bolts bending/pulling through relatively thin steel.The mounting hardware will require punching two ~ 3/8in holes into your bed and side walls. Fastening the bed’s bolts were tricky and required a partner(or magnetic wrench, XL socket extension) to hold a wrench under the bed.After tightening the allen key insert screws, the uprights became very sturdy with no play. This rack held an 80# 16’ kayak for a 30 mile round trip going 65 mph. I will update this review with more trips.
Carlos
Comentado en Canadá el 7 de diciembre de 2021
Bought for Colorado 2016. Truck box was too high for the short insert sleeves, so I welded a longer L bracket to the bottom to even the height to the box. I used nut inserts into the truck bed, not supplied. And the ladder posts were too too tall for my liking, so I cut the bottoms off about 5”. Last, to have a stop for the ladder, I welded one of the 5” pieces to the center of the front post. You know, the horizontal flat your ladder rests on.Also, it comes with set screws and a hex wrench to fasten the posts to the sleeves. That’s crap. Unless you plan to just leave them permanently installed. I rethreaded the holes to fit eye hook bolts so I could use my fingers to tighter or uninstall the posts.So yes I had to modify them, but they fit the way I want.
Alfonso
Comentado en México el 10 de noviembre de 2021
Es muy buena la calidad y fácil de instalar
Snugs
Comentado en los Estados Unidos el 25 de marzo de 2019
I've bought two of these now; I'm a fan. Good value. As others have noted, the quality control is a little off, but nothing that a rubber mallet cant fix. It's a ladder/lumber rack; it's not a fine watch. Also, there was missing hardware (again), but I have a drawer of spare nuts and bolts. If you are buying a rack, then presumably you know how to build things. Once installed, it is very versatile and practical.
calude bellware
Comentado en Canadá el 11 de abril de 2018
Great product for the price. Strong built and easy to install, only 3 bolts per pedestal. However, drilling of 6 holes of 3/6'' is required. I use it mainly for kayak transport and it works fine.
Productos recomendados
Mex $639.00
Mex $ 293 .00 Mex $293.00
Mex $320.00
Mex $ 144 .00 Mex $144.00
Mex $899.88
Mex $ 404 .00 Mex $404.00