Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

MEAN WELL RT-50D AC-DC Power Supply Triple Output 5V 24V 12V 5 Amp

Envío gratis en pedidos superiores a Mex $600.00

Mex $631.90

Mex $ 303 .00 Mex $303.00

En stock
Nombre del modelo RT-50D
Marca MEAN WELL
Dispositivos compatibles Personal Computer
Tipo de conector ATX
Potencia de salida 51 Vatios
Factor de forma ATX
Vataje 51 watts
Método de enfriamiento Aire
Configuración del conector PCI-Express 20+4 pines
Voltaje de entrada máximo 264 Volts (AC)


51W AC/DC enclosed switching power supply +5Volts 5Amps (channel 1) +12Volts 1Amp (channel 2) +24Volts 1.5Amps (channel 3) specifications: size (L x W x H) (inches): 3.9 x 3.8 x 1.4 ripple and noise (mV p-p): 80 load regulation: 1.0 percent line regulation: 0.5 percent input: 88-264vac 47-63hz 5G vibration able to withstand 300VAC surge input for 5 seconds short-circuit/overload/overvoltage protection 3-year warranty certifications: UL/cul/TUV/CE/CB for more 12 Volt power supplies. Detailed specifications: primary output voltage (VDC): 5 output current (a): 3 maximum output power (W): 51 family: rt-50 additional output voltages (VDC): 24 | 12 input voltage (VAC): 88 to 264 input frequency: 47 to 63 maximum input current (a): 1.3 output connector Type: screw terminal block number of outputs: 3 product Type: AC to DC power supply efficiency ( percent ): 80 minimum isolation voltage: 3000V operating temperature-min (CEL): -25 operating temperature-max (CEL): 70 Length (inch): 3.9 width (inch): 3.8 height (inch): 1.4 agency approvals: UL/cul/TUV/CE/CB Type: auto switching style: multiple output.


thomas clifford hatfield
Comentado en los Estados Unidos el 3 de febrero de 2025
Works great and is quite compact for everything it does. I use mine to power an arduino project.
Colby
Comentado en los Estados Unidos el 27 de agosto de 2024
Currently powering a 1541 floppy drive. Works well and stays cool.
hexhead
Comentado en los Estados Unidos el 6 de mayo de 2024
I’m building an environmental controller for my hobby scale mycology tent.I needed 5V for the microcontroller, 12v for the fan, and 24v for the mist maker. This power supply allowed me to use a smaller footprint enclosure as no voltage transformers were required.The available amperage for the 12v and 24v taps is only 1 amp. per line, but that was (barely) sufficient for my needs.I have a 12v unit from Meanwell of the same footprint/model series that has been in use 24/7 for the past two years, so I expect that this unit is of similar quality, and will likely last a long time.
brian
Comentado en los Estados Unidos el 10 de diciembre de 2024
It looks like a solid little unit but my item came from Amazon with no wiring diagram or explanation on where to attach out all your leads. I've got the AC input wired up but I'm not finding the 24 volt on any of the settings I've got the 5 volt and 12 volt but I can't locate the 24 volt and there's still a couple of pins that I don't know even what they go to.
drp103
Comentado en los Estados Unidos el 20 de abril de 2021
I bought the RT-50D for an audio preamplifier project. I wanted to build a preamp with a power supply built inside the chassis. The line level preamp is the Nelson Pass-designed KORG Nutube B1. It needs 24 volts to operate. I used the 12 volt taps to power a PHONO preamp PCB. Both boards and the power supply fit neatly inside the chassis.The 5 volt taps are used to power a Bluetooth module. It too resides inside the chassis.The preamp kit has a power on/off switch, a selector switch (PHONO, AUX, BLUETOOTH), and an ALPS volume pot. There are wires running everywhere, and the chassis is very compact.So far so good. With the signal wires running near the power supply and the three PCBs in such close proximity to each other and the power supply, all of it crammed inside very compact chassis, one would think (as I did at first) that the whole thing would be noisy. Playing music would be less than optimal with hiss and hum heard through the speakers coming from the power supply. Or the signal wire would be picking up unwanted noise. But that's not the case. Very quiet, indeed.Even the PHONO preamp is very quiet. Turntables have a grounding wire. That wire gets screwed to a thumb screw on the back of the chassis; from there another wire goes directly to the power supply's ground screw. Very simple yet very effective. No hum. No noise. I was pleasantly surprised to say the least.So far so good. Time will tell how reliable the power supply is! Highly Recommended
Productos recomendados

Mex $4,050.01

Mex $ 1,881 .00 Mex $1,881.00

4.9
Elegir