No hay artículos en el carro
No hay artículos en el carro Características:
Diseño de soporte de ángulo plano en forma de L, fácil de instalar.
Especificaciones del producto:
Nombre del producto: Pastlla Corner Brace
Material: Hierro
Tamaño: 38 x 38 mm. Diámetro del orificio de montaje: 4 mm. Cantidad del agujero: 4 agujeros.
Color: plateado.
Consulta la imagen para ver el tamaño detallado.
50 placas de reparación en forma de L con tornillos.
Debido a la medición manual, puede haber un margen de error de 1 a 2 mm. Puede haber un 5% de error de color debido a los diferentes monitores.
William L. Foster
Comentado en los Estados Unidos el 16 de agosto de 2024
Purchased to use with my smaller DYI framing projects. Nice size and does provide adequate corner support.
ColeDaron
Comentado en los Estados Unidos el 8 de mayo de 2024
I'm new at building furniture. I'm fairly inexperienced but working at perfecting my carpentry skills so I wasn't sure how well I'd do with my trendal bench I built for my primary suite closet. The cuts weren't perfect I don't have the cool tools to make great clean cuts yet, so they were messy and jagged since I was working with a partial board shelf I fashioned into a front for my bench to match my DIY kit built Ins from the home improvement shop.These corner pieces fixed up those messy edges and were the right size to fit into the peel and stick trim I added to cover the messy edges. The peel and stick trim wasn't holding as well in some spots because of the jaggedy edges, so I used these to screw into those and my trindal bench front. The screws are strong enough and didn't strip like a lot of screws you get in mass quantity tend to do, so easy to work with. Be sure you screw one side at a time so you can confirm it's level / square before you get to the otherside. I like doing the outside top then outside bottom then the inside top and then inside bottom in that order for easiest install.I recommend pre-drilling your holes for the screws, much easier using the thinnest bit you've got, then use only one of them as a guide (so you don't mess up or ding your others), mark it with black marker and save it with the rest. Then hold that up to your angle, make sure it's level, then glue, clamp or be careful and hold with your hand wearing a clean glove and drill out the four holes. This helped because I was going through a layer of partical board and aluminum. It helped me double check I was level. Then switched to my Phillips bit and attached each one. Was a fun project, not hard or frustrating and instant results. Highly recommend.
Dsm
Comentado en los Estados Unidos el 29 de mayo de 2024
I could bend these with my fingers.They're very cheaply made. Really only good for possibly picture frames
Alicia
Comentado en los Estados Unidos el 6 de marzo de 2024
Easy and worth the money
Savvy shopper
Comentado en los Estados Unidos el 27 de junio de 2023
Very good quality for the picture frame my husband build for me. Helped to secure corners very happy
Productos recomendados
Mex $359.01
Mex $ 186 .00 Mex $186.00