No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Placa de Circuito PCB Instrumento Caja de Enfriamiento de Aluminio DIY Proyecto Electrónico Caja del Gabinete Caja de Protección para Productos Electrónicos Disipación de Calor
Performance Buen rendimiento: la carcasa de la placa de circuito tiene una buena disipación de calor y un excelente rendimiento de blindaje electromagnético.
DesignDiseño de tipo dividido: la caja de aluminio adopta un diseño de tipo dividido, puede ensamblar y diseñar la caja que desee usted mismo.
Ventaja: la caja de aluminio ha sido sometida a un granallado superficial y un tratamiento cepillado, que es resistente al desgaste y hermoso, y tiene una sensación cómoda en las manos.
Ockham
Comentado en los Estados Unidos el 27 de enero de 2024
This is a nice little box. Well made, with dimensional accuracy and tight tolerances. I build a number of custom small electronic devices, many of which require about this much space. This box is above average in quality, and comes with features that make it ideal for custom-permanent installation of switching equipment, custom processors, transformer interfaces and small power supplies and regulators, etc.This box gets it done, with no fuss and a bit of extra elegance compared to some DIY builder boxes.It is a little different form factor than the usual die-cast stomp box, and better suited for the aforementioned interfaces, PSU, etc., but it could in a pinch be made to be a stomp box, especially for something that has a fully built board that you could slide in the slots on the inside of the extruded body.Be aware that the primary body consists of a four-sided aluminum extrusion, so whatever you build won't be built "inside the box". It will definitely be a "build and put in the box" situation. Note that the extruded body has a couple of interior slots suitable for sliding in a PCB. The PCB will have to pretty much be single sided component wise if you are using traditional through hole stuff. There appears to be enough clearance to allow for surface mount on both sides when using the extrusion slot for the pCB.All in all, a good buy.
Larry Huff
Comentado en Canadá el 14 de enero de 2021
I used this project case to build a line input switch-box for additional audio inputs. It was a perfect case for this little project. I wouldn't hesitate to reorder for similar small projects. Well made and looks good.
Fagner
Comentado en Canadá el 21 de mayo de 2020
Good
A. T. Stolk
Comentado en Canadá el 30 de abril de 2020
I am unable to close the box with all screws, because the holes do not line up on the metal parts.
Productos recomendados
Mex $131.00
Mex $ 70 .00 Mex $70.00
Mex $187.18
Mex $ 99 .00 Mex $99.00