No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Descripción
Fuerte y fiable
Cada diámetro está disponible en una longitud, para elegir simplemente selecciona un diámetro, luego selecciona el anclaje.
Fácil de usar
Acepta pernos con roscas gruesas, extiende toda la longitud del anclaje, sobresale en materiales base donde la resistencia es un problema, fácil de usar.
Duradero
Mecanizado a partir de material de aleación de zinc, resistente a la corrosión, estructura fuerte, rendimiento fiable y resistencia excepcional.
Danny
Comentado en los Estados Unidos el 13 de julio de 2024
I spent a while researching all the different options for anchoring my patio umbrella, etc.Very happy I decided to get this one. Have since used these in flagstone, brick, and concrete. I drill the holes with a 1/2" carbide masonry SDS+ bit. Bought a set of 1/4-20 stainless bolts, also here on Amazon. The varying lengths in that set (every 1/4") is very helpful in getting exactly the right installation.Very secure, while still being completely removable - leaving only a 1/2" hole - if needed.
Luc Hubert
Comentado en Canadá el 10 de mayo de 2024
Excellent produit
Toolmanazon
Comentado en Canadá el 2 de marzo de 2024
At first glance these look great. Exact same as the ones I buy from a supplier. When I used them over half had casting flash so bad inside the opening that I couldn’t get rod to go through. I had to snap them open and clean the flashing off. Frustrating on the job. The threads were also not quite right as most were high friction when threading in rod or bolts. They did work fine and are holding as one would expect but the factory needs to up the quality control for me to recommend these. Meh
Walter
Comentado en los Estados Unidos el 24 de octubre de 2024
My concrete block walls don't seem to play nice with Tapcon's, so I used some of these to mount a Kayak holder (approx 100 lbs with kayak).They hold very well once you get them installed. I had to slightly wallow out the holes past the size drill bit indicated, that could be on my drill bit tho. If the holes are a bit tight you can thread in a bolt and lightly tap them in with the head of the bolt.
D. C. Curtis
Comentado en los Estados Unidos el 28 de septiembre de 2024
I used these to mount two steel gates to brick walls. The brick was fairly soft so I needed something which would grip evenly and securely. These worked better than any of the alternative anchors I tried. I still needed to make sure the hole was drilled perfectly for these to grip well.
Productos recomendados
Mex $451.00
Mex $ 243 .00 Mex $243.00
Mex $835.00
Mex $ 450 .00 Mex $450.00
Mex $58.00
Mex $ 31 .00 Mex $31.00
Mex $424.00
Mex $ 199 .00 Mex $199.00
Mex $394.46
Mex $ 213 .00 Mex $213.00
Mex $411.98
Mex $ 222 .00 Mex $222.00