No hay artículos en el carro
No hay artículos en el carroSoporte de electrodos de alta calidad estilo AF-3. Características del producto: Amperaje máximo: 300 A. Tamaño del cable: hasta 2/0. Capacidad para electrodos de hasta 1/4 pulgadas. Descripción; constreñido con cuerpo de nailon resistente. Mandíbulas de alta conductividad y conectores de cable. Muelle helicoidal de alta resistencia para un agarre máximo del electrodo. Incluye: conector de cable y llave Allen.
Martin Grenier
Comentado en Canadá el 8 de julio de 2024
très solide, je recommande
Rene Lantigua García
Comentado en los Estados Unidos el 23 de julio de 2024
No es de mucha calidad pero para el precio que tiene está bien
Texas Mike
Comentado en los Estados Unidos el 15 de enero de 2024
This holds rods great and works fine.
JimF
Comentado en los Estados Unidos el 16 de agosto de 2020
No instructions of any type in the box. Solid brass and a strong spring which will easily hold a 1/16" rod and on up. Two small metal accessories came with the holder and there is no instruction regarding their purpose. After pondering the two pieces of metal supplied with the holder, it occurred to me that the copper foil was to help make the connection between the holder and the welding lead. Since the opening is much larger than the welding lead, I made an alloy insert from some 9/16" aluminum rod. I cross-drilled it 8.5mm in line with the electrode set screw, then tapped from the set screw hole into the insert. With the copper foil wrapped around it, the fit was perfect. I drilled another hole lengthwise halfway through the insert for the copper welding lead. The set screw then screws through the brass handle and into the aluminum insert, clamping both the wiring lead and the insert nice and tight.As to the plastic handle, I suppose you could use the radiused steel piece to lie flat in the inside of the plastic handle, but the screw did not seem long enough to tighten it. So, I flipped the piece over and used it as a sort of spring which holds some tension on the plastic handle when the set screw bears against it. I tightened it only enough to make the plastic handle secure. Over-tightening it would eventually cause some damage. A short section of closed-cell foam pipe insulation inside the plastic handle, and a piece of rubber tubing over the welding lead acted as strain relief. Now that it's all done, I am quite satisfied with it. Instructions would sure help!
Mackie.pope
Comentado en los Estados Unidos el 7 de mayo de 2020
Seems durable. Like others said only a single screw pushing out on the handle mine was relatively hard to turn like the hole was ovaled so it stays in place if it does come loose will put some blue thread locker on it. NOT A BIG DEAL for $17 better than the brittle plastic on my original one that was cheaply Chinese made. This one feels of better quality even if it’s from China. But didn’t specify if it was.For the price it’s a great value.Not sure it would make it in a commercial environment.Ran 5 6013 1/8” and it was very smooth.Only took about a minute to install and I was back in business.
Productos recomendados
Mex $253.00
Mex $ 151 .00 Mex $151.00
Mex $113.00
Mex $ 65 .00 Mex $65.00
Mex $470.41
Mex $ 225 .00 Mex $225.00