No hay artículos en el carro
No hay artículos en el carro
Aprende Electrónica para principiantes
La mejor manera de aprender electrónica, o comenzar la electrónica como pasatiempo, es comenzar a construir circuitos. No necesitas saber cómo funcionan los circuitos o qué hacen las piezas al principio. Al construir circuitos, aprenderá sobre diferentes piezas y componentes electrónicos, cómo leer diagramas de circuito, así como sobre herramientas básicas y principios electrónicos.
Craig S
Comentado en los Estados Unidos el 23 de febrero de 2025
Great for a little fun and education
Mark Dymek
Comentado en los Estados Unidos el 10 de agosto de 2024
So it’s a no frills kit and gets the job done. However i do have a few issues. one is as others have pointed out no instructions other then the card that shows a picture of the board however its upside down. took me a minute to figure this out so i just totally ignored the card. also its probably the cheapest paper i’ve ever seen and i dont know did they use finger paint? the colors of the bands on the resistors aren’t anywhere close to what they should be.
kris redick
Comentado en los Estados Unidos el 12 de junio de 2024
This is the perfect DIY learn how to solder starter point this will teach you how to identify different capacitors and how to read ohms to make sure that you're getting the appropriate amount of electricity passing through each circuit. It's a very basic plan, the most difficult part about it is being able to see the thin colored lines that identify the different ohms rating. But if you take your time and use a magnifying glass it's well worth the experience.
Customer
Comentado en los Estados Unidos el 18 de mayo de 2024
The instructions were very easy to follow and it was awesome at teaching me how to solder better.
chandler
Comentado en los Estados Unidos el 24 de junio de 2023
Most of the parts are decent quality and the overall build is challenging yet rewarding. The only issue I had was the battery connection wire didn't work which caused me lots of aches and pains to figure out if I shorted something on the board or if the connecter was faulty. In the end, the connector was found defective. In the pictures above you see the makeshift contraption I had to make to get the product to work. Additionally, a light would not work (the now red one). I believe this was my fault but it should be noted in case anyone else has this problem. Really great tool to learn and had a blast building it's just sad that the end result was poor from a faulty male plug-in.
Productos recomendados
Mex $339.00
Mex $ 152 .00 Mex $152.00
Mex $8,249.94
Mex $ 1,881 .00 Mex $1,881.00
Mex $367.53
Mex $ 198 .00 Mex $198.00