No hay artículos en el carro
No hay artículos en el carroPaul Shaffer
Comentado en los Estados Unidos el 29 de marzo de 2025
Good
Paula blackburn
Comentado en Canadá el 20 de noviembre de 2024
Exactly what needed
Garry Dlouhy
Comentado en Canadá el 30 de octubre de 2024
I used these splicers to spice 1/0 copper wire. They worked well but the sharp, square corners required a lot of splicing tpae to "build Up'. I again used them to splice some 2 AWG wire, but this time I radiused the corners with a grinder. Made the insulating a whole lot easier.
adam
Comentado en los Estados Unidos el 13 de septiembre de 2024
perfect fit with great quality and value. perfect fit for 4/0
BuckeyeFan442
Comentado en los Estados Unidos el 23 de diciembre de 2022
Used 3 of these to connect 4/0 AL to 2/0 CU and they are great.Hex screws allow you to torque these down really tight according to the specs included.These are about as small as possible - great for tight places.I put large heat shrink on wires before connecting and then wrapped the splice with several wraps of tape, then slid heat shrink down and heated.The hole is plenty big enough for 4/0 AL and the wire hole has a stop in the middle so you can be sure you get enough wire in each side.I typically use the fully insulated splices but couldnt get them this time so I tried these and they are great. Much smaller in length and costs much less.
Productos recomendados
