No hay artículos en el carro
No hay artículos en el carroNingún filtro está garantizado para eliminar todas las interferencias, solo si la fuente de interferencia en la trayectoria eléctrica corresponde a la frecuencia del filtro, tiene el mejor efecto. En una palabra, añadir un filtro debe ser mejor que ningún filtro. El mayor efecto del filtro es mejorar la estabilidad del equipo y prolongar la vida útil del equipo.
JG44070
Comentado en los Estados Unidos el 26 de febrero de 2024
Washing machine (direct drive Samsung) when agitating, causing some cheap Chinesium LED bulbs to flicker. Some bulbs ok, others flickered. Wired a male and female cord end onto this suppressor and fed washer through it. Reduced but didn’t completely eliminate flicker. Barely noticeable now.
Customer
Comentado en Canadá el 25 de octubre de 2023
Cannot use in Canada, the product not match web photo
Dan Clementi
Comentado en los Estados Unidos el 10 de enero de 2023
Every time the treadmill in our house was in use, broad-spectrum severe interference was generated that made radio reception difficult. I am a ham radio operator and radio listener and it was enough to be a show-stopper under some circumstances. The treadmill in question is a NordicTrack 2150, but the manufacturer sells these (or some variant) under many brand names. I installed this EMI filter and the problem has disappeared, with spurs now below the random noise level. Quantitatively, I'd estimate at least a 40-50dB sort of improvement on low-frequency and mid-frequency bands (e.g. AM radio).Installation was not terribly difficult.(EDIT: Modify your equipment at your own risk. I make no representations regarding the safety, or effect on agency approvals, of this modification.)Release the strain relief from the treadmill frame, then unlatch it from the existing power cable. Then re-latch the strain relief closer to the plug, so that when reinserted in the frame, there will be enough slack cable inside the frame. Find a suitable mounting spot for the filter first, so you'll know if you have enough slack. I drilled two 1/8" holes in the frame of the treadmill and used self-tapping sheet-metal screws. Then cut the cable and remove the outer jacket from both cut ends. Strip the ends of the conductors and crimp on ring terminals and you're done. Make sure that you connect the green wire of the power cord and the green wire from the treadmill frame to the ground terminal of the filter.
Scott Akam
Comentado en los Estados Unidos el 26 de noviembre de 2022
Got this for my tube guitar amp hoping to reduce some of the high frequency electrical noise. The quality looks good and it was easy to use. I didn't really hear any difference with or without the filter but it was worth a shot.
dave
Comentado en los Estados Unidos el 26 de marzo de 2021
My new microwave tripped the AFCI/GFCI only when a small item (one cup of water) was being heated.Added this filter inside a box between the outlet and the microwave, and that fixed the problem.Have had previous good experience putting one of these in a fluorescent light ceiling fixture that was interfering with TV reception. Also worked great.
Productos recomendados
Mex $455.73
Mex $ 250 .00 Mex $250.00
Mex $205.00
Mex $ 110 .00 Mex $110.00
Mex $799.00
Mex $ 375 .00 Mex $375.00
Mex $391.10
Mex $ 195 .00 Mex $195.00
Mex $1,041.00
Mex $ 499 .00 Mex $499.00