No hay artículos en el carro
No hay artículos en el carro1. Soporta 100Ω a 1 kΩ (0°C) resistencia al platino RTD (PT100 a PT1000); (La resistencia del módulo utiliza 430R) 2. Compatible con conexiones de sensor de 2 cables, 3 cables y 4 cables. 3. Interfaz compatible con SPI; resolución ADC de 4,15 bits con una resolución de temperatura nominal de 0,03125 °C (variable con no linealidad RTD); 5. La precisión total se mantiene a 0,5 ° C (0,05% de la escala completa) en todas las condiciones de trabajo; 6 entradas VREF totalmente diferenciales; 7. Tiempo de conversión: 21 ms (máximo); 8. Detección de fallos integrada para aumentar la estabilidad del sistema: circuito abierto (RTD, cortocircuito RTD a voltaje fuera del rango o cortocircuito de los componentes RTD).
Bryan Boettcher
Comentado en los Estados Unidos el 4 de marzo de 2024
To use with the reference code for the Adafruit Arduino library and a 3-wire RTD, you need to cut the jumper trace on the "24 3" pads. The default configuration is for 2/4 wire RTD's, and this will cause the sensor to read off by a few hundred degrees. Cutting the trace and putting a solder blob over the center and 3 pads corrects it if you're using a 3-wire RTD.There is an additional solder pad to jumper underneath the negative side, "labelled 2/3 wire".In summary:4 wire RTD: no soldering3 wire RTD: jumper the 2/3 wire pad below the negative terminals, cut the trace on the "2/4 3" pads above the reference resistor, and jumper between center and "3".2 wire RTD: jumper the 2/3 wire pad below the negative, jumper the 2 wire pad below the positive, leave the "2/4 3" pads alone.
Andrew
Comentado en los Estados Unidos el 1 de septiembre de 2024
Boards are not rated for 5v even though they have 3-5v written all over them. Voltage regulator gets smoldering hot at 5v and then the chip is dead. Fried the first 2 by connect VIN to 5v and 0v to GND. Third one I tried at 3.3V and while it didn't get burning hot it also still didn't work. Chinese clone of an actual adafruit chip that doesn't work.
Productos recomendados