No hay artículos en el carro
No hay artículos en el carroA push nut has no threading but has an inward facing flange. The flange is meant for quick assembly as no tools are needed, the nut can be pushed into place. This is meant to be a permanent application unless specific tools are obtained to cut them off.
LUDABREW
Comentado en los Estados Unidos el 31 de marzo de 2025
Best nipple cover on the market.
Hank
Comentado en los Estados Unidos el 1 de marzo de 2025
As a previous reviewer said, it doesn't fit. I ordered this along with a 3/8" inch steel rod from Amazon and there was no way put it on. If you purchase this be sure your axle is just a bit smaller than 3/8"
mountain_meadows
Comentado en Canadá el 7 de diciembre de 2024
Product was delivered next day !! Impressive !! Couldn't find this particular size of pushnut fastener in town here so was pleased to find it on Amazon and even more pleased when it arrived next day. Fastener worked perfect for the job it was intended for!! Excellent service and excellent product !
pk Mass
Comentado en los Estados Unidos el 28 de noviembre de 2024
Fits perfectly on my Ariel’s snowblower discharge chute.
Calcutrex
Comentado en los Estados Unidos el 30 de abril de 2021
Used these to “cap” fiberglass rods I was driving to hold landscape timbers in place. Needed a lot of them, and wasn’t economical to buy “2-packs” locally. Worked great and seem to hold on to fiberglass, though they are best designed for steel rod. If the fiberglass breaks down at the grab point, I can still trim them and recap. Not a problem of the pushnut, though. Metal rods rust in the ground, so I hope this works for years to come.
Productos recomendados
Mex $691.00
Mex $ 338 .00 Mex $338.00
Mex $494.22
Mex $ 266 .00 Mex $266.00
Mex $362.14
Mex $ 170 .00 Mex $170.00