No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Cómo elegir una resistencia adecuada
Cuando la temperatura de funcionamiento cambia, la resistencia requerida también será diferente, por lo que la resistencia adecuada debe seleccionarse de acuerdo con la temperatura de funcionamiento. Se recomienda comenzar con una resistencia de 82 ohmios inicialmente, y una semana de monitoreo.
Resultado 1: La luz ECO es siempre o la mayor parte del tiempo apagado, es fiable y no necesita cambiarse.
Resultado 2: Las luces ECO todavía se iluminan con frecuencia en condiciones normales de conducción, elige una mayor resistencia.
Resultado 3: CEL se enciende y no desaparece después de una semana, elige una resistencia más baja.
El paquete incluye:
- 1 x completo para arnés VCM con enchufes
- 2 resistencias de 68 ohmios
- 2 resistencias de 82 ohmios
- 2 resistencias de 100 ohmios
- 2 resistencias de 120 ohmios
- 1 carcasa protectora negra
TXJURGEN
Comentado en los Estados Unidos el 16 de marzo de 2025
The ECO mode light stopped showing on the dashboard with the initial 82 Ohms configuration at 80F. So far so good after a week of usage. I expected going to the next Ohms level sometime in May when average temps would be 90F and then again by end of June when temps will be over 100F for the Summer. I hope it will work then. I had to cover the wire ends with self bonding aislant tape to get added protection vs heat and dust. I am thinking on making my own dial muzzle which will be easier to configure than this piano style switchboard. No complaints, very good for the price. Regards to you all from the Gulf of Texas.
Rob Magee
Comentado en los Estados Unidos el 15 de febrero de 2025
Easy to install, though it did not come with instructions. Just look up a video online, you simply set the resistance that you want, install the cover on the resistor box, unplug your coolant temperature sensor, plug that connector into one end of this device and plug the other end of this device into your sensor. It took less than 5 minutes on my Odyssey.I saw a couple other reviews say this doesn't work because it's wired wrong. Either those reviewers just happened to get a defective one or something, because it worked perfectly for me. Took it on a 2 hour trip right after installation and the ECO light in my van did not come on at all, and the van ran perfectly. For under $20, the ease of installation and piece of mind to know that it will prevent the VCM system from damaging my engine makes this a no-brainer. That it comes with extra resistors in case you need to replace one is a bonus.
brian johnson
Comentado en los Estados Unidos el 12 de febrero de 2025
As another review stated, the resistor is on the red wire and should be on the black. Great concept and I wish it was built correctly and worked but unfortunately it doesn't. Theres no way all the other reviews are written by actual people saying it worked because it would be impossible for it to.
Luke
Comentado en Canadá el 10 de abril de 2025
Working so far.. goodbye ECO mode.
Hardy
Comentado en Canadá el 24 de abril de 2025
Worked as described...solved my problem
Productos recomendados
Mex $653.00
Mex $ 300 .00 Mex $300.00
Mex $706.82
Mex $ 367 .00 Mex $367.00
Mex $199.99
Mex $ 113 .00 Mex $113.00
Mex $1,287.96
Mex $ 643 .00 Mex $643.00
Mex $339.00
Mex $ 162 .00 Mex $162.00