Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

VEVOR - Bomba de prueba de presión, bomba de llenado, bomba de prueba de presión, bomba de prueba hidrostática, bomba de prueba de presión hidráulica, probador de presión de agua de 25 bares/2.5 MPa,

Envío gratis en pedidos superiores a Mex $600.00

Mex $2,499.99

Mex $ 1,099 .00 Mex $1,099.00

En stock

1.Nombredeltalle:25bar - 3gallon


Acerca de este artículo

  • Medidor de presión de tres unidades de 25 bares: esta bomba de prueba de presión hidrostática tiene un amplio rango de prueba que alcanza hasta 25 bar / 2,5 MPa. El manómetro muestra la presión fiable en dos unidades: bar/MPa. También está equipado con dos manos que difieren en negro y rojo y, por lo tanto, son fáciles de leer.
  • Sistema de dos válvulas: nuestra bomba de prueba está equipada con dos válvulas de cobre que permiten un ajuste preciso de la presión. Además, el sistema de doble válvula permite resultados de medición precisos y seguros a través de la autoprueba de la bomba.
  • Presurización rápida y fácil: el pistón de la bomba lubricada permite una presurización rápida y fácil, mientras que el mango de ahorro de trabajo y el mango de goma antideslizante reducen la fuerza de mano requerida y hacen que el funcionamiento sea simple y menos tedioso.
  • Depósito de agua de 3.2 galones. Esta bomba de mano portátil viene con un tanque de agua de 3.2 galones, que está equipado con una pared gruesa y un excelente rendimiento de sellado, por lo que no es fácil filtrar durante un período de tiempo más largo. Y el tubo de ensayo puede soportar alta presión y garantizar una medición precisa.
  • Amplia aplicación: la bomba de presión se utiliza para pruebas de presión de agua o aceite en tuberías en edificios residenciales e industriales y recipientes industriales. Se puede utilizar en la línea de calefacción, recipiente a presión, riego, manguera contra incendios, alcantarillado, etc


Bomba de prueba VEVOR, bomba de prueba de presión, bomba de llenado, bomba de prueba de presión, bomba de prueba hidrostática, bomba de prueba de presión hidráulica, probador de presión de agua de 25 bares/2.5 MPa, volumen del tanque de 12 L


Scott P.
Comentado en Australia el 19 de junio de 2024
Great little unit for the price.Two things that let it down:1. the fitting on the end is something random, so I was quick to cut that off and put my ideal connector on it.2. I use it for hydraulic oil, and it could use a small lid, just to keep things dropping into the tank and also from any fluid movement that splashes.But otherwise, value for money is great.
brads
Comentado en Canadá el 8 de marzo de 2023
I added a coupling connector on a short hose and it works fine to connect with my boiler system to pressurize and add chemicals. I found the tank is larger than necessary when doing maintenance as the volume I need to add is often much less than a liter. I found if I add in a smaller plastic bucket just under the pump intake there is less waste when I need to feed in smaller quantities.
Roger
Comentado en los Estados Unidos el 31 de agosto de 2022
Ease of use. As a licensed plumbing contractor for 30 plus this is great. Previously used the aluminum with check valves built in. Repaired many of them. Granted have not used this for very long but the storage tank saves from having hose attached. The only better one I have used is the old cast iron body pumps. Heavy as all get go but great. Add a little wikiing on the pump handle and good for a long time.
EPI
Comentado en los Estados Unidos el 24 de agosto de 2022
I used this unit to seat the bead on a frankenstein rim/tire combination. It took 90 PSI of air to seat one side but the other side refused to seat. I don't like high pressure air with rubber bladders so I opted for the safer route of water. Water doesn't explode to the same degree that air does. You might get a loud pop but you won't get a boom and a visit from the FBI. I now have a single use tool that will just gather dust but it served its purpose well and I have no regrets in buying it.
duncan culver
Comentado en los Estados Unidos el 10 de junio de 2019
This unit looked new, and worked well. I could see no evidence of cosmetic damage described in the listing. A clearer specification for the mating fitting should be made. The thread on the pressure-hose was a female nut, 1/2" BSP, but as the seal was to the face of a rubber washer, it worked fine with a standard American 1/2" NTP male fitting. Great value; a fraction of the cost of a new unit from a plumbing supply house.
Productos recomendados

Mex $11,303.51

Mex $ 1,881 .00 Mex $1,881.00

4.8
Elegir

Mex $4,450.00

Mex $ 1,881 .00 Mex $1,881.00

4.6
Elegir