John M
Comentado en Canadá el 4 de enero de 2025
This was for my hot water circulation system. It replaced a Grundfos unit that was over 4 x as expsnsive. It's quiet, easy to install and works as it should.
Jenny
Comentado en los Estados Unidos el 27 de enero de 2025
Works as intended, exceeds expectations. Was easy for me to install. I bought it to circulate water in my chicken water system to help prevent frozen water when the temperature drops below freezing. I like the 2 different speed options. We recently had near zero temperatures and the pump kept working, no problems whatsoever. I would buy again if needed in other situations, great value for the money.
bwana
Comentado en Canadá el 30 de noviembre de 2024
Used for continuous hot water at our kitchen sink. Works wonderfully and at a great price
Dennis
Comentado en los Estados Unidos el 27 de octubre de 2024
I am a contractor so from my prospective it was easy to install. Overall I give it a 5 but individually quality is 3.5, price is a 10 and installing a 4, - also I bought 2 the other one is for my cnc plasma table fluid filtration system.I needed to get a 3/4” union for the pump to water heater but that’s normal with most pumps.For the low price of $35 the quality is great.It does have flaws its not perfect but if you are on a budget thes is i great pump and wow save you on waisted water and gas to heat it. I installed it on my water heater witch is the preferred installation. I used an inexpensive valve at the fertherest bathroom sink. But I recommend buying the stainless steal valve.Installation including the bypass valve tool 20 minutes I already had electric at the water heater. My only concern is it says it’s automatic on off but so far it on all the time. So I’m going to install a dusk to dawn Timmie and if it continues to run all day I’ll add ap pressure sensor switch or it may be the plastic bypass valve not shutting off if so an other reason to go with the better SS valve. But the pump is worth the $.
Stephen Ghantous
Comentado en Canadá el 24 de diciembre de 2023
This pump has been running in a closed hot water loop to bring hot water to the farthest faucet where it used to take up to a full minute to have hot water. The pump is plugged into a smart plug that is triggered by a smart motion detector light switch in the bathroom where the farthest faucet is located, and runs for one minute starting when you walk into the bathroom. There's another smart plug at the kitchen sink (these smart plugs have a button on them and can be programmed to trigger a different smart device) that will run the pump for 30 seconds. This setup works really well and saves water that would otherwise go down the drain, as well as saving wear and tear on the well pump.Note however that finding the right connectors was not easy. What finally worked for me was to bring the pump to Home Depot and test fit connectors in the store. In my case the fittings are SharkBite brand swivel connectors for 3/4" pex to 3/4" FNPT model: UC530LFCA.