No hay artículos en el carro
No hay artículos en el carroSamuel Antonio
Comentado en México el 15 de abril de 2025
Exelente
Dustin1226
Comentado en los Estados Unidos el 4 de agosto de 2024
Used these to get rear camber back in spec. Had almost 1.5 degrees of neg camber due to age on a 99 civic. Put these is and camber is a perfect 0.0.Could probably use these if you wanted to "stance" a car but I bought them to put it back in spec. Highly recommended 👌 👍 👏 💯
Angela
Comentado en Canadá el 28 de agosto de 2024
I bought these for my 1999 civic coupe, they did not sit flush against the body where your 2 bolts go in, I had to take a grinder and cut a little shoulder off on each tab that was just a tiny bit too big so that they would sit in the gap flush. They do their job good once modified a little
Alvaro L
Comentado en México el 19 de noviembre de 2024
Compre este producto camber para honda civc wagon 1988 los instale y se kebraron los hules que van hacia el lado de adentro de las dos camber ,mala calidad
kris
Comentado en México el 24 de octubre de 2024
Se ven de calidad, llegaron pronto, pero se escucha muy fuerte el rechinar de los bujes, ¿alguna solución?
Kristen
Comentado en los Estados Unidos el 12 de septiembre de 2024
Got what I paid for, lasted 1 month and inner bushings fell apart.
Juice
Comentado en Canadá el 10 de septiembre de 2024
Not made right. Low QC part. TBD once installed... Finally installed and seems OK. I wanted to get "Stanced" out of them, however only achieved 4 degrees and maxed out. If you're looking to correct your camber this is good enough. If you want to get 5-6 degrees look elsewhere. I needed more! Rubbing and Scrubbing for life ;p
Adam
Comentado en los Estados Unidos el 16 de junio de 2023
I specifically bought these due to steel construction advertised and not wanting questionable aluminum used for suspension bits.Well, the bodies on these units are aluminum BUT they are also much higher quality than I was expecting from cheapies from Amazon.They come dry, so you will want to disassemble and lubricate the bushings.So I feel a little lied to but also with an ultimately higher quality than I expected soooo overall good things?
Manuel G.
Comentado en México el 5 de diciembre de 2023
De muy mala calidad , se le dañaron los los soportes en 2 meses de uso . No lo recomiendo
Roberto
Comentado en México el 25 de septiembre de 2023
Excelente calidad y fácil instalación
Daniel Hernández
Comentado en México el 15 de abril de 2023
Ya tengo un mes y sin problemas seve de muy buena calidad
Productos recomendados