Irma huizar
Comentado en los Estados Unidos el 12 de abril de 2025
Not to good material
Juana Lara
Comentado en los Estados Unidos el 18 de mayo de 2024
Satisfecha
Nelly Andrea Aka
Comentado en Canadá el 21 de octubre de 2024
Pas mal très pratique
Benjamin
Comentado en los Estados Unidos el 8 de marzo de 2023
I do meal prep, and the size is great to add rice, meals, spaghetti, etc. Not sure if it needs to be thicker like other comments. But never had any problems with plastic breaking/leaking
💜💚💙theconsciousbabe💜💚💙
Comentado en los Estados Unidos el 16 de septiembre de 2023
They were too wide and had to return. I guess if you're looking for this specific size they're okay but they didn't work out for me. The picture is a bit deceiving but that's why you need to pay attention to the measurements which in this case was my fault. The best size for these are the 2x12 inch which they don't have.
Customer
Comentado en Canadá el 19 de febrero de 2020
Perfect replacement tips for soldering iron. I solder everyday and these tips hold up great. Says good for 40000 soldering points for each one and so far still going on the same one. They work perfectly if your soldering iron tips can be replaced. Will definitely buy again. Great purchase. Good bang for your buck
Duane
Comentado en Canadá el 21 de diciembre de 2020
fine
marc
Comentado en los Estados Unidos el 3 de mayo de 2019
Nice kit with several different ends of various sized. Comes "pre-tinned" so you don't have to spend a lot of time messing with it. Works perfectly with the X-Tronic Model #3020
Aidan I
Comentado en los Estados Unidos el 9 de agosto de 2018
For how little this pack costs I was surprised at the quality of the tips. As a forklift technician I often have to solder 10ga+ wires and the flat/blade tips hold heat very well! Coating other than the tip isn't great, but they're quality where it counts
Steven W
Comentado en los Estados Unidos el 20 de agosto de 2017
Purchased for a RadioShack branded soldering station. These replacement tips were recommended but known to need a slight adjustment for best fit.All that was required was to slightly grind down the end of the tip that fits over the heating element by about 20thou. This ensures good conduct between the tip and the heating element.After that, these tops work fine.