No hay artículos en el carro
No hay artículos en el carroChris Hooker
Comentado en Canadá el 25 de marzo de 2025
Good stuff works well
Customer
Comentado en los Estados Unidos el 15 de febrero de 2025
We are installing LED strip lights in our basement. This allows us to connect to a light switch. This product is easy to use. Props to this company, my fist package was empty, looks like it was cut / torn and maybe the product fell out. They replaced it. I will buy agin from them.
ISMAEL
Comentado en México el 8 de julio de 2024
De excelente calidad, ya los conecte para un proyecto y funcionan muy bien.
miah
Comentado en los Estados Unidos el 22 de noviembre de 2024
Installed two of these as power sources for some Reolink Floodlight cameras so that I could hardwire them. It's been about 3 months and we've seen about -15*F once so far and both units are working great.They also fit perfectly inside of the Reolink base!
Paul B.
Comentado en Canadá el 28 de septiembre de 2024
I gave this 4 stars and not five because I’ve only had it for about a week.Product works as expected and its compact size is perfect for my application. I used it in my stove hood fan to change out bulbs to LED.
Carlos Garza
Comentado en México el 11 de abril de 2024
Funcionó sin ningún problema
JustMe1
Comentado en los Estados Unidos el 11 de enero de 2023
The original power supply in my outdoor fixture was a constant current supply. It had broken and was causing the light to flicker. I found the original replacement on Amazon, but it was about 3 to 4 times the cost of this unit. The Wattage of this unit was slightly higher, and this unit was a constant Voltage supply instead of the original's constant current. LEDs want to be biased with a constant current. When using a constant Voltage supply typically a series resistor is used with the LEDs to adjust and set a constant current through the LEDs. I did not have a resistor with the "high" Wattage rating needed to place in series and set the correct current through the LEDs. So instead, I used series diodes. Each diode added would drop the Voltage to the LEDs and lower the current. I picked the number of series diodes based on the measured current. I knew that the original supply was specified to provide 700mA of constant current. So, I added and removed series diodes until I had a constant current close to 700mA. Reassembled the outdoor light with the new parts and it works great. No flickering, just a nice constant light output and the repair cost me 1/3 the cost of using an original replacement.
Victor Alejandro Luna Acosta
Comentado en México el 20 de diciembre de 2022
Se calienta demasiado lo deje 8 hrs continuas conectado
Productos recomendados